Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Practice for Impact Flexibility of Organic Coatings
Přeložit název
NORMA vydána dne 1.12.2020
Označení normy: ASTM D6905-20
Datum vydání normy: 1.12.2020
Kód zboží: NS-1013161
Počet stran: 4
Přibližná hmotnost: 12 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
cracking failure, extrusion indentation, impact failure, intrusion indentation,, ICS Number Code 25.220.60 (Organic coatings)
Significance and Use | ||||||||||||||
5.1?Coatings attached to substrates are subjected to damaging impacts during the manufacture of articles and their use in service. This impact resistance practice has been found to be useful in predicting the performance of organic coatings for their ability to resist cracking caused by impacts. |
||||||||||||||
1. Scope | ||||||||||||||
1.1?This practice covers a procedure for determining the ability of a coating film and its substrate to resist shattering, cracking, or chipping when the film and substrate are distended beyond their original form by impact. 1.2?This practice does not measure impact resistance but uses rapid impact to improve Test Methods D522, a test method for flexibility. Since the impact of the coating is almost instantaneous, all of the problems associated with time variables in the mandrel tests are eliminated. 1.3?This practice is similar in content but not technically equivalent to Test Method D2794. 1.4?The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.5?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||
2. Referenced Documents | ||||||||||||||
|
Chcete mít jistotu, že používáte pouze platné technické normy?
Nabízíme Vám řešení, které Vám zajistí měsíční přehled o aktuálnosti norem, které používáte.
Chcete vědět více informací? Podívejte se na tuto stránku.
Poslední aktualizace: 04.11.2024 (Počet položek: 2 209 323)
© Copyright 2024 NORMSERVIS s.r.o.