Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ASTM D6839-15
Standard Test Method for Hydrocarbon Types, Oxygenated Compounds and Benzene in Spark Ignition Engine Fuels by Gas Chromatography
Automaticky přeložený název:
Standardní testovací metoda pro uhlovodíkových typů, zoxidovaných sloučenin a benzenu v zážehových motorových paliv plynovou chromatografií
NORMA vydána dne 1.12.2015
Informace o normě:
Označení normy: ASTM D6839-15
Poznámka: NEPLATNÁ
Datum vydání normy: 1.12.2015
Kód zboží: NS-623595
Počet stran: 10
Přibližná hmotnost: 30 g (0.07 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Kategorie - podobné normy:
Anotace textu normy ASTM D6839-15 :
Keywords:
aromatics, gas chromatography, gasoline, hydrocarbon type, multidimensional gas chromatography, naphthenes, olefins, oxygenates, saturates, spark-ignition engine fuels,, ICS Number Code 71.040.40 (Chemical analysis)
Doplňující informace
| Significance and Use | ||||||||||||||
|
5.1 A knowledge of spark-ignition engine fuel composition is useful for regulatory compliance, process control, and quality assurance. 5.2 The quantitative determination of olefins and other hydrocarbon types in spark-ignition engine fuels is required to comply with government regulations. 5.3 This test method is not applicable to M85 and E85 fuels, which contain 85 % methanol and ethanol, respectively. |
||||||||||||||
| 1. Scope | ||||||||||||||
|
1.1 This test method covers the quantitative determination of saturates, olefins, aromatics and oxygenates in spark-ignition engine fuels by multidimensional gas chromatography. Each hydrocarbon type can be reported either by carbon number (see Note 1) or as a total. Note 1: There can be an overlap between the C9 and C10 aromatics; however, the total
is accurate. Isopropyl benzene is resolved from the
C1.2 This test method is applicable to
spark-ignition engine fuel with total aromatic content up to 50 %
(V/V), total olefinic content up to 30 % (V/V) and oxygen compounds
up to 15 % (V/V).
1.3 This test method is not intended to determine individual hydrocarbon components except benzene. 1.4 Oxygenates as specified in Test Method D4815 have been verified not to interfere with hydrocarbons. Within the round robin sample set, the following oxygenates have been tested: MTBE, ethanol, ETBE, and TAME. Other oxygenates can be determined and quantified using Test Method D4815 or D5599. 1.5 This test method includes a relative bias section for U.S. EPA spark-ignition engine fuel regulations for total olefins reporting based on Practice D6708 accuracy assessment between Test Method D6839 and Test Method D1319 as a possible Test Method D6839 alternative to Test Method D1319. The Practice D6708 derived correlation equation is only applicable for fuels in the total olefins concentration range from 0.2 % to 18.2 % by volume as measured by Test Method D6839. The applicable Test Method D1319 range for total olefins is from 0.6 % to 20.6 % by volume as reported by Test Method D1319. 1.6 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||
| 2. Referenced Documents | ||||||||||||||
|
Doporučujeme:
