Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Cummins M11 High Soot Test
Automaticky přeložený název:
Standardní zkušební metoda pro Cummins M11 vysoké Soot testu
NORMA vydána dne 1.5.2004
Označení normy: ASTM D6838-04
Poznámka: NEPLATNÁ
Datum vydání normy: 1.5.2004
Kód zboží: NS-36732
Počet stran: 29
Přibližná hmotnost: 87 g (0.19 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
crosshead, Cummins M11, diesel engine oil, oil filter plugging, sludge, soot-induced stress, ICS Number Code 27.020 (Internal combustion engines)
Significance and Use | ||||||||||||||||||||||||||||||||||||||||||||||||||||
This test method was developed to assess the performance of an engine oil to control engine wear and deposits under heavy duty operating conditions selected to accelerate soot production, valve train wear, and deposit formation in a turbocharged, aftercooled four-stroke-cycle diesel engine. This test method may be used for engine oil specification acceptance when all details of this test method are in compliance. Applicable engine oil service categories are included in Specification D 4485. The test method was correlated with field service data, determined from side-by-side comparisons of two or more oils in on-highway service. These data are contained in a research report.6 These same field service oils were used to develop the operating conditions of this test method. The design of the engine used in this test method is representative of many, but not all, modern diesel engines. This factor, along with the accelerated operating conditions should be considered when extrapolating test results. |
||||||||||||||||||||||||||||||||||||||||||||||||||||
1. Scope | ||||||||||||||||||||||||||||||||||||||||||||||||||||
1.1 This test method is commonly referred to as the Cummins M11 High Soot Test (HST). The test method defines a heavy-duty diesel engine test procedure conducted under high soot conditions to evaluate oil performance with regard to valve train wear, sludge deposits, and oil filter plugging. 1.2 The values stated in SI units are to be regarded as the standard. The values given in parenthesis are for information only. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. See Annex A1 for general safety precautions. |
||||||||||||||||||||||||||||||||||||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||||||||||||||||||||||||||||||||||||
|
Chcete mít jistotu, že používáte pouze platné technické normy?
Nabízíme Vám řešení, které Vám zajistí měsíční přehled o aktuálnosti norem, které používáte.
Chcete vědět více informací? Podívejte se na tuto stránku.
Poslední aktualizace: 24.11.2024 (Počet položek: 2 206 712)
© Copyright 2024 NORMSERVIS s.r.o.