ASTM D6824-23

5.1?This test method is intended for use in the laboratory or field in evaluating aviation turbine fuel cleanliness.

5.2?A change in filtration performance after storage, pretreatment, or commingling can be indicative of changes in fuel condition.

5.3?Relative filterability of fuels may vary, depending on filter porosity and structure, and may not always correlate with results from this test method.

5.4?Causes of poor filterability in industrial/refinery filters include fuel degradation products, contaminants picked up during storage or transfer, incompatibility of commingled fuels, or interaction of the fuel with the filter media. Any of these could correlate with orifice or filter system plugging, or both.

1.1?This test method covers a procedure for determining the filterability of aviation turbine fuels (for other middle distillate fuels, see Test Method D6426).

1.2?This test method is not applicable to fuels that contain undissolved water.

1.3?The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard.

1.4?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.