Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Determining Filterability of Aviation Turbine Fuel
Přeložit název
NORMA vydána dne 1.10.2018
Označení normy: ASTM D6824-13(2018)
Poznámka: NEPLATNÁ
Datum vydání normy: 1.10.2018
Kód zboží: NS-906349
Počet stran: 7
Přibližná hmotnost: 21 g (0.05 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
aviation turbine fuels, distillate fuels, filterability, fuel cleanliness, fuel filterability, gas oils,, ICS Number Code 75.160.01 (Fuels in general)
Significance and Use | ||||||||||||||||||
5.1 This test method is intended for use in the laboratory or field in evaluating aviation turbine fuel cleanliness. 5.2 A change in filtration performance after storage, pretreatment, or commingling can be indicative of changes in fuel condition. 5.3 Relative filterability of fuels may vary, depending on filter porosity and structure, and may not always correlate with results from this test method. 5.4 Causes of poor filterability in industrial/refinery filters include fuel degradation products, contaminants picked up during storage or transfer, incompatibility of commingled fuels, or interaction of the fuel with the filter media. Any of these could correlate with orifice or filter system plugging, or both. |
||||||||||||||||||
1. Scope | ||||||||||||||||||
1.1 This test method covers a procedure for determining the filterability of aviation turbine fuels (for other middle distillate fuels, see Test Method D6426). Note 1: ASTM specification fuels falling within the scope of
this test method are Specifications D1655 and D6615 and the military fuels covered in
the military specifications listed in 2.2.
1.2 This test method is not applicable to fuels that contain undissolved water. 1.3 The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||
|
Chcete mít jistotu o platnosti užívaných předpisů?
Nabízíme Vám řešení, abyste mohli používat stále platné (aktuální) legislativní předpisy.
Chcete vědět více informací? Podívejte se na tuto stránku.
Poslední aktualizace: 29.04.2024 (Počet položek: 2 896 215)
© Copyright 2024 NORMSERVIS s.r.o.