Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Practice for Sampling and Preparation of Fresh or Salt-Preserved (Cured) Hides and Skins for Chemical and Physical Tests
Přeložit název
NORMA vydána dne 1.4.2020
Označení normy: ASTM D6715-13(2020)
Datum vydání normy: 1.4.2020
Kód zboží: NS-990641
Počet stran: 3
Přibližná hmotnost: 9 g (0.02 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
chemical tests, cured hides, de-haired hide, fresh hide, hair-on hide, lot, physical tests, preparation, salt-preservation, salted hides, sampling, unit,, ICS Number Code 59.140.20 (Raw skins, hides and pelts)
Significance and Use |
3.1 The sampling procedures described in this practice have been designed to ensure random sampling of salt-preserved hides and skins for physical and chemical tests. Fresh or salt-preserved hides are natural products and as such are subject to extensive variability. The physical and chemical properties vary considerably depending on location on that specific hide, side, or skin from which the test sample is taken. Random sampling of specimens from a predefined location and orientation minimizes test bias and variability. This practice defines these parameters. 3.2 In general, tests carried out upon fresh or salt-preserved hides require composite lot samples generated using the preparation methods described within this practice. Subsequent tests typically require those composite samples to be in two forms: 3.2.1 Expressed Hide Fluid—where residual hide fluid is pressed from cleaned individual hair-on or de-haired hide sample, then equal volumes of each extracted fluid are blended together to create the composite sample. Note 1: Sample may be de-haired prior to pressing.
3.2.2 Hide Material Sample—where equal quantities of cleaned hair-on or de-haired hide material are blended together to create a representative composite sample. Note 2: Samples may be de-haired prior to
compositing.
|
1. Scope |
1.1 This practice covers the sampling and preparation of fresh or salt-preserved (cured) hides for physical and chemical tests. The hides or skins to be tested are grouped into lots. Each lot is randomly sampled in such a manner as to produce a representative sample of that lot. This lot sample may be used to determine compliance of the lot with applicable specification requirements, and on the basis of results, the lot may be accepted or rejected in its entirety. 1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
Chcete mít jistotu o platnosti užívaných předpisů?
Nabízíme Vám řešení, abyste mohli používat stále platné (aktuální) legislativní předpisy.
Chcete vědět více informací? Podívejte se na tuto stránku.
Poslední aktualizace: 04.11.2024 (Počet položek: 2 209 323)
© Copyright 2024 NORMSERVIS s.r.o.