Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Wet and Dry Yarn-on-Yarn Abrasion Resistance (Withdrawn 2016)
Automaticky přeložený název:
Standardní zkušební metoda pro mokré a suché příze-on-příze Odolnost proti oděru
NORMA vydána dne 15.9.2007
Označení normy: ASTM D6611-00(2007)
Poznámka: NEPLATNÁ
Datum vydání normy: 15.9.2007
Kód zboží: NS-35870
Počet stran: 8
Přibližná hmotnost: 24 g (0.05 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
abrasion, rope, yarn, Abrasion resistance--textile fabrics/fibers, Dry abrasion resistance, Wet abrasion resistance, Yarn properties, ICS Number Code 59.080.20 (Yarns)
Significance and Use | ||||||||||
This test method is intended for testing dry and wet abrasion resistance of manufactured fiber yarns. This test method is especially useful for ropes intended for use in the marine environment. The test method has been used with yarns having linear densities ranging from 70 to 300 tex, but may be used with yarns outside these ranges. Limited interlaboratory correlation testing has been conducted to date. Single-laboratory testing, in accordance with ASTM practices, has now been conducted. Additional interlaboratory testing, in accordance with ASTM practices, will be conducted after approval of a definitive test method. Test results should be used with caution pending completion of interlaboratory testing. This test method is not recommended for acceptance testing of commercial shipments in the absence of reliable information on between-laboratory precision. If there are differences of practical significance between reported test results for two or more laboratories, comparative tests should be performed to determine if there is a statistical bias between them, using competent statistical assistance. As a minimum the test samples used should be as homogeneous as possible, be drawn from the material from which the disparate test results were obtained, and be randomly assigned in equal numbers to each laboratory for testing. Other materials with established test values may be used for this purpose. The test results from the two or more laboratories should be compared using a statistical test for unpaired data, at a probability level chosen prior to testing. If a bias is found, either its cause must be found and corrected, or future test results must be adjusted in consideration of the known bias. This test method is conducted at one or several applied tensions that may depend upon the yarn material and size. The number and magnitudes of applied tensions and the number of eight specimen sets generally are agreed upon in a material specification or contract order. Guidance on determining the appropriate number and magnitudes of applied tensions is given in Annex A2. |
||||||||||
1. Scope | ||||||||||
1.1 This test method describes the measurement of abrasion resistance properties for manufactured fiber yarns in dry and wet conditions. 1.2 This test method applies to manufactured yarns used in rope making. 1.3 The values stated in SI units are to be regarded as standard. The values given in parentheses are provided for information only. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||
2. Referenced Documents | ||||||||||
|
Poslední aktualizace: 22.12.2024 (Počet položek: 2 217 000)
© Copyright 2024 NORMSERVIS s.r.o.