Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Specification for Flexible Cellular Rubber Chemically Blown
Přeložit název
NORMA vydána dne 1.7.2020
Označení normy: ASTM D6576-20
Datum vydání normy: 1.7.2020
Kód zboží: NS-1000114
Počet stran: 8
Přibližná hmotnost: 24 g (0.05 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
This specification establishes requirements for chemically blown cellular rubber. Cellular rubber may be classified into two types: Type I which is open cell or sponge rubber and Type II which is closed cell or expanded rubber. Both types are divided into three grades: Grade A which is oil-and flame-resistant, Grade B which has no requirements for oil ,flame resistance, or low temperature, and Grade C which is low-temperature resistant. Each type and class has been divided into three different conditions. Each condition is based on a specific range of firmness as expressed by compression deflection as follows: super soft, soft, soft-medium, medium, medium-firm, and firm conditions. Several tests shall be performed in order to determine the following physical properties of cellular rubber: compression deflection, low-temperature resistance, accelerated aging, recovery, flame resistance, shrinkage, water absorption, oil aging, and color.
Keywords:
cellular, closed-cell, elastomeric, flexible, open cell, rubber,, ICS Number Code 83.100 (Cellular materials)
1. Scope | ||||||||||||||||||||||||||
1.1 This specification establishes requirements for chemically blown cellular rubber. 1.2 In the case of conflict between the provisions of this specification and those of detailed specifications or test methods for a particular product, the latter shall take precedence. 1.3 Unless specifically stated otherwise, by agreement between the purchaser and the supplier, all test methods shall be performed in accordance with the test methods specified in this specification. 1.4 The values stated in SI units are to be regarded as the standard. The inch-pound units given in parentheses are for information only. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 There is no known ISO equivalent to this specification. Note 1: This specification was revised using the updated test
methods and specifications in the latest version of Specification
D1056.
1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||||||||||
|
Chcete pravidelně odebírat informace o nově vycházejících normách z celého světa a to zcela zdarma?
Přihlašte se k odběru. Vše je velice jednoduché a absolutně ZDARMA.
Na výběr máte vydavatele z celého světa.
Poslední aktualizace: 26.04.2024 (Počet položek: 2 896 057)
© Copyright 2024 NORMSERVIS s.r.o.