Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Carbon Black—Total and External Surface Area by Nitrogen Adsorption
Automaticky přeložený název:
Standardní zkušební metoda pro Carbon Black & ndash, Total a plochy povrchu adsorpcí dusíku
NORMA vydána dne 1.6.2014
Označení normy: ASTM D6556-14
Poznámka: NEPLATNÁ
Datum vydání normy: 1.6.2014
Kód zboží: NS-35620
Počet stran: 5
Přibližná hmotnost: 15 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
Brunauer/Emmett/Teller, carbon black, B.E.T., nitrogen adsorption, nitrogen surface area, statistical thickness surface area, surface area by multipoint B.E.T. method, external surface area, ICS Number Code 71.060.10 (Chemical elements)
Significance and Use | ||||||||
4.1 This test method is used to measure the total and external surface area of carbon blacks based on multipoint nitrogen adsorption. The NSA measurement is based on the B.E.T. theory and it includes the total surface area, inclusive of micropores, pore diameters less than 2 nm (20 Å). The external surface area, based on the statistical thickness method (STSA), is defined as the specific surface area that is accessible to rubber. 4.2 CTAB Surface Area (formerly Test Method D3765) has been withdrawn. The CTAB value may be estimated from the STSA value using Eq 1. The equation is based on a linear regression of the STSA and CTAB measured values of the SRB 5 standards. |
||||||||
1. Scope | ||||||||
1.1 This test method covers the determination of the total surface area by the Brunauer, Emmett, and Teller (B.E.T. NSA) theory of multilayer gas adsorption behavior using multipoint determinations and the external surface area based on the statistical thickness surface area method. 1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. (The minimum safety equipment should include protective gloves, sturdy eye and face protection). |
||||||||
2. Referenced Documents | ||||||||
|
Historická
1.11.2013
Historická
1.12.2012
Historická
1.11.2013
Historická
1.4.2008
Historická
15.12.2008
Historická
1.8.2013
Poslední aktualizace: 22.11.2024 (Počet položek: 2 206 568)
© Copyright 2024 NORMSERVIS s.r.o.