Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Guide for Sampling Wastewater With Automatic Samplers
Automaticky přeložený název:
Standardní Guide pro odběr vzorků odpadní vody s automatickým samplerů
NORMA vydána dne 1.9.2012
Označení normy: ASTM D6538-12
Poznámka: NEPLATNÁ
Datum vydání normy: 1.9.2012
Kód zboží: NS-35548
Počet stran: 6
Přibližná hmotnost: 18 g (0.04 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
automatic sampler, composite, sample, wastewater, water sampling, ICS Number Code 13.060.45 (Examination of water in general)
Significance and Use | ||
4.1 This guide provides persons responsible for designing and implementing wastewater sampling programs with a summary of the types of automatic wastewater samplers, discusses the advantages and disadvantages of the different types of samplers and addresses recommended procedures for their use. The field settings are primarily, but not limited to, open channel flows in enclosed (e.g., sewer) systems or open (e.g., streams or open ditches, and sampling pressure lines) systems. Type
|
Advantages |
Disadvantages |
Manual |
Low capital cost |
Increased variability due to sample handling |
|
Personnel can compensate for various situations |
Inconsistency in collection |
|
Personnel can document |
High cost of labor assuming composite or multiple grab samples are collected |
|
Low maintenance |
Repetitious and monotonous task for personnel |
|
Extra samples can be collected |
|
|
||
Automatic |
Consistent samples |
Considerable maintenance for batteries and cleaning; susceptible to plugging by solids |
|
Decreased variability caused by sample handling |
Restricted in size to the general specifications |
|
Minimal labor requirement for sampling |
Greater potential for sample contamination |
|
Capable of collecting multiple |
May be subject to damage by vandals |
|
|
High capital cost |
1.1 This guide covers the selection and use of automatic wastewater samplers including procedures for their use in obtaining representative samples. Automatic wastewater samplers are intended for the unattended collection of samples that are representative of the parameters of interest in the wastewater body. While this guide primarily addresses the sampling of wastewater, the same automatic samplers may be used to sample process streams and natural water bodies.
1.2 The guide does not address general guidelines for planning waste sampling activities (see Guide D4687), development of data quality objectives (see Practice D5792), the design of monitoring systems and determination of the number of samples to collect (see Practice D6311), operational details of any specific type of sampler, in-situ measurement of parameters of interest, data assessment and statistical interpretation of resultant data (see Guide D6233), or sampling and field quality assurance (see Guide D5612). It also does not address sampling groundwater.
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3.1 Exception—The inch-pound units given in parentheses are for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Practice for Decontamination of Field Equipment Used at Waste Sites |
|
Standard Practice for Generation of Environmental Data Related to Waste Management Activities: Development of Data Quality Objectives |
|
Standard Terminology for Waste and Waste Management |
|
Standard Guide for Data Assessment for Environmental Waste Management Activities |
|
Standard Guide for Generation of Environmental Data Related to Waste Management Activities: Selection and Optimization of Sampling Design |
|
Standard Guide for General Planning of Waste Sampling |
|
Standard Guide for Quality Planning and Field Implementation of a Water Quality Measurement Program |
Historická
15.6.2010
Historická
1.5.2011
Historická
15.6.2012
Historická
1.5.2011
Historická
15.7.2013
Historická
1.1.2013
Chcete mít jistotu, že používáte pouze platné technické normy?
Nabízíme Vám řešení, které Vám zajistí měsíční přehled o aktuálnosti norem, které používáte.
Chcete vědět více informací? Podívejte se na tuto stránku.
Poslední aktualizace: 22.11.2024 (Počet položek: 2 206 568)
© Copyright 2024 NORMSERVIS s.r.o.