Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ASTM D6287-17
Standard Practice for Cutting Film and Sheeting Test Specimens
Přeložit název
NORMA vydána dne 15.12.2017
Informace o normě:
Označení normy: ASTM D6287-17
Datum vydání normy: 15.12.2017
Kód zboží: NS-807823
Počet stran: 3
Přibližná hmotnost: 9 g (0.02 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Kategorie - podobné normy:
Anotace textu normy ASTM D6287-17 :
Keywords:
film, sample preparation, sheeting,, ICS Number Code 25.100.01 (Cutting tools in general)
Doplňující informace
| Significance and Use | ||||||
|
3.1 Many test methods including Test Methods D882, D2838, F88, F1921/F1921M, and F2029 require the use of narrow strips of varying length. The quality of the sample preparation directly affects test results. This practice describes three techniques for preparing samples with straight, clean, parallel edges with no visible imperfections. Note 2: After cutting, each specimen should be examined
visually to insure the edges are undamaged (free of nicks). On a
periodic basis specimen edge quality should be evaluated by
microscopic examination. To determine when cutting blades need to
be replaced or sharpened, a control chart of tensile strength and
percent elongation at break (see Test Method D882) of a uniform material may be
maintained. Tensile strength and percent elongation at break will
decrease as the quality of specimen cutting decreases.
|
||||||
| 1. Scope | ||||||
|
1.1 This practice covers equipment and techniques for cutting film and sheeting specimens for testing.1.2 The values given in SI units are to be considered standard. The values given in parentheses are for information only. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Note 1: There is no known ISO equivalent to this
standard.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||
| 2. Referenced Documents | ||||||
|
Doporučujeme:
Aktualizace zákonů
Chcete mít jistotu o platnosti užívaných předpisů?
Nabízíme Vám řešení, abyste mohli používat stále platné (aktuální) legislativní předpisy.
Chcete vědět více informací? Podívejte se na tuto stránku.
