Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ASTM D6265-23
Standard Practice for Separation of Contaminants in Polymers Using an Extruder Filter Test
Přeložit název
NORMA vydána dne 1.2.2023
Informace o normě:
Označení normy: ASTM D6265-23
Datum vydání normy: 1.2.2023
Kód zboží: NS-1135820
Počet stran: 4
Přibližná hmotnost: 12 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Kategorie - podobné normy:
Anotace textu normy ASTM D6265-23 :
Keywords:
contamination, extruder filtration test, polyolefins, recycled plastics,, ICS Number Code 83.020 (Manufacturing processes in the rubber and plastics industries)
Doplňující informace
| Significance and Use | ||||||||
|
5.1?Problems with extrusion and subsequent processing of the material are caused, in part, by the presence of paper, metal, gels, incompatible polymers, or other extraneous contamination found in polymers. |
||||||||
| 1. Scope | ||||||||
|
1.1?This practice covers a means to separate the unmolten particles, gels, and impurities contaminating a polymer sample. The procedure may be used to remove gels and incompatible materials that may cause imperfections in the final extruded product. Under pressure, most gels will break up or deform and pass through a wire mesh filter, however high molecular weight gels may not break up or deform. 1.2?Materials isolated on a wire mesh filter can be identified by spectroscopic or other analytical means. Note 1:?Although not presented as a quantitative method, the
procedure presented in this practice may be used to provide
quantitative results at the discretion of the user. The user
assumes the responsibility to verify the reproducibility of
quantitative results. Detection limit depends on the mesh size of
the filter screen, but the procedure is generally applicable to the
separation of immiscible contaminants present at concentrations
greater than 0.1 %.
1.3?The values stated in SI units are to be regarded as standard. 1.4?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Note 2:?There is no known ISO equivalent to this standard. 1.5?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||
| 2. Referenced Documents | ||||||||
|
Odebírejte informace o nově vydaných normách ZDARMA:
Chcete pravidelně odebírat informace o nově vycházejících normách z celého světa a to zcela zdarma?
Přihlašte se k odběru. Vše je velice jednoduché a absolutně ZDARMA.
Na výběr máte vydavatele z celého světa.
