Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Guide for Alkaline Stabilization of Wastewater Treatment Plant Residuals
Přeložit název
NORMA vydána dne 1.5.2019
Označení normy: ASTM D6249-19
Poznámka: NEPLATNÁ
Datum vydání normy: 1.5.2019
Kód zboží: NS-949964
Počet stran: 7
Přibližná hmotnost: 21 g (0.05 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
alkaline stabilization, biosolids, high-lime byproducts, sewage sludge, stabilization, wastewater treatment plant,, ICS Number Code 13.060.30 (Sewage water)
Significance and Use | ||||||
4.1 Operators of power and other plants producing alkaline by-products and wastewater treatment plant operators needing to treat and manage wastewater solids will find this guide helpful in dealing with their materials. 4.2 This guide provides the tests, procedures, and parameters that should be considered to significantly reduce pathogens in wastewater treatment plant solids by the addition of manufactured or by-product alkaline materials1.1 This document provides guidance for use of reactive alkaline materials (quicklime, hydrated lime, high lime fly ash, or other byproducts) for treating wastewater solids (biosolids) to reduce pathogen levels and achieve compliance with regulatory requirements. Federal (40 CFR, Part 503) regulations for use or disposal of biosolids became effective on March 22, 1993; refer to USEPA regulations and guidance documents for information on other treatment processes or for specific requirements for use or disposal of biosolids. 1.2 Additional requirements may be imposed by individual states, and these are available through state regulatory agencies that issue permits for treatment and use or disposal, or both, of biosolids. 1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.4 This guide does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||
2. Referenced Documents | ||||||
|
Poslední aktualizace: 25.11.2024 (Počet položek: 2 206 719)
© Copyright 2024 NORMSERVIS s.r.o.