Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Determining the Volume of Bulk Materials Using Contours or Cross Sections Created by Direct Operator Compilation Using Photogrammetric Procedures
Přeložit název
NORMA vydána dne 1.12.2018
Označení normy: ASTM D6172/D6172M-18
Datum vydání normy: 1.12.2018
Kód zboží: NS-938484
Počet stran: 8
Přibližná hmotnost: 24 g (0.05 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
aerial, inventory, photogrammetric, photography, stockpile, volume,, ICS Number Code 17.060 (Measurement of volume, mass, density, viscosity)
Significance and Use |
4.1 This test method audits the volume of material in a stockpile and is used with a density value to calculate a tonnage calculation value used to compare the book value to the physical inventory results. This test method is used to determine the volume of coal or other materials in a stockpile. |
1. Scope |
1.1 This test method covers procedures concerning site preparation, technical procedures, quality control, and equipment to direct the efforts for determining volumes of bulk material. These procedures include practical and accepted methods of volumetric determination. 1.2 This test method allows for only two volume computation methods. 1.2.1 Contour Test Method—See 8.1.1 and 9.1. 1.2.2 Cross-Section Test Method—See 8.1.2 and 9.2. 1.2.3 This test method requires direct operator compilation for both contours and cross-section development. 1.2.4 The use of Digital Terrain Model software and procedures to create contours or cross sections for volume calculation is NOT encompassed in this test method. Note 1: A task group has been established to develop a test
method for Digital Terrain Modeling (DTM) procedures. It will
address all known data collection procedures such as conventional
ground survey, photogrammetry, geodetic positioning satellite
(GPS), and so forth.
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
Poslední aktualizace: 28.04.2024 (Počet položek: 2 896 137)
© Copyright 2024 NORMSERVIS s.r.o.