Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Specification for Chemically Modified Asphalt Cement for Use in Pavement Construction (Includes all amendments and changes 12/20/2021).
Přeložit název
NORMA vydána dne 15.12.2021
Označení normy: ASTM D6154-15(2021)e1
Datum vydání normy: 15.12.2021
Kód zboží: NS-1045096
Počet stran: 2
Přibližná hmotnost: 6 g (0.01 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
This specification covers asphalt cements that have been modified by the addition of a chemical gellant. The asphalt cement used to prepare the chemically modified asphalt cement shall be prepared by the refining of crude petroleum by suitable methods. Chemically modified asphalt cements are normally produced by addition of a chemical stabilizer. However, any asphalt modifier may be used that will give the required test results when blended with the desired asphalt. Different test methods shall be performed in order to determine the following properties of the cement: penetration, viscosity, flash point using Cleveland open cup, solubility in trichloroethylene, softening point, residue from thin-film oven test.
Keywords:
chemical gellant, chemical stabilizer, chemically modified asphalt cement, viscosity,, ICS Number Code 91.100.10 (Cement. Gypsum. Lime. Mortar),93.080.20 (Road construction materials)
1. Scope | ||||||||||||||||
1.1?This specification covers asphalt cements that have been modified by the addition of a chemical gellant. It was developed to provide a reference for specifying chemically modified asphalt cement and reflects the properties of currently available commercial products. The tests are intended to measure degree of modification, not performance characteristics. This is not intended to be a performance-based specification. 1.2?Chemically modified asphalt cements are normally produced by addition of a chemical stabilizer. However, any asphalt modifier may be used that will give the required test results when blended with the desired asphalt. 1.3?The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.4?The text of this standard references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard. 1.5?The following precautionary statement pertains to the test method portion only, Section 5, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||||
2. Referenced Documents | ||||||||||||||||
|
Chcete mít jistotu o platnosti užívaných předpisů?
Nabízíme Vám řešení, abyste mohli používat stále platné (aktuální) legislativní předpisy.
Chcete vědět více informací? Podívejte se na tuto stránku.
Poslední aktualizace: 08.11.2024 (Počet položek: 2 210 012)
© Copyright 2024 NORMSERVIS s.r.o.