Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Practice for Separation and Identification of Poly(Vinyl Chloride) (PVC) Contamination in Poly(Ethylene Terephthalate) (PET) Flake
Přeložit název
NORMA vydána dne 1.2.2023
Označení normy: ASTM D5991-23
Datum vydání normy: 1.2.2023
Kód zboží: NS-1135818
Počet stran: 4
Přibližná hmotnost: 12 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
contamination, poly(ethylene terephthalate) (PET), poly(vinyl chloride) (PVC), recycled plastics,, ICS Number Code 83.080.10 (Thermosetting materials)
Significance and Use | ||||||
5.1?Presence of even low concentrations of PVC in recycled PET flakes results in equipment corrosion problems during processing. The PVC contamination level shall dictate the market for use of the recycled polymer in secondary products. Procedures presented in this practice are used to identify the PVC contamination in recycled PET flakes. Note 4:?These procedures may also be used to estimate the
concentration of PVC contamination.
|
||||||
1. Scope | ||||||
1.1?This practice covers four procedures for separation and qualitative identification of poly(vinyl chloride) (PVC) contamination in poly(ethylene terephthalate) (PET) flakes. Note 1:?Although not presented as a quantitative method,
procedures presented in this practice may be used to provide
quantitative results at the discretion of the user. The user
assumes the responsibility to verify the reproducibility of
quantitative results. Data from an independent source suggest a PVC
detection level of 200 ppm (w/w) based on an original sample weight
of 454 g.
1.2?Procedure A?is based on different fluorescence of PVC and PET when these polymers are exposed to ultraviolet (UV) light. 1.3?Procedure B?is an oven test based upon the charring of PVC when it is heated in air at 235?C. 1.4?Procedures C and D?are dye tests based on differential staining of PVC and PET. Note 2:?Other polymers (for example, PETG) also absorb the
stain or brightener. Such interferences will result in false
positive identification of PVC as the contaminant.
1.5?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Note 3:?There is no known ISO equivalent to this standard. 1.6?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||
2. Referenced Documents | ||||||
|
Chcete mít jistotu, že používáte pouze platné technické normy?
Nabízíme Vám řešení, které Vám zajistí měsíční přehled o aktuálnosti norem, které používáte.
Chcete vědět více informací? Podívejte se na tuto stránku.
Poslední aktualizace: 21.11.2024 (Počet položek: 2 206 478)
© Copyright 2024 NORMSERVIS s.r.o.