Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ASTM D5989-14
Standard Specification for Extruded and Monomer Cast Shapes Made from Nylon (PA)
Automaticky přeložený název:
Standardní specifikace pro extrudované a monomer Cast tvary z nylonového ( PA)
NORMA vydána dne 1.5.2014
Informace o normě:
Označení normy: ASTM D5989-14
Poznámka: NEPLATNÁ
Datum vydání normy: 1.5.2014
Kód zboží: NS-33340
Počet stran: 7
Přibližná hmotnost: 21 g (0.05 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Anotace textu normy ASTM D5989-14 :
Keywords:
monomer cast, nylon, plates, recycled plastic, rod, shapes, sheet, tubular bar, ICS Number Code 83.020 (Manufacturing processes in the rubber and plastics industries)
Doplňující informace
| 1. Scope | ||||||||||||||||
|
1.1 This specification covers requirements and test methods for the material, dimensions, and workmanship, and the properties of extruded and cast sheet, plate, rod and tubular bar, excluding pipe and fittings, manufactured from nylon or monomers. 1.2 The properties included in this specification are those required for the compositions covered. Section 1.3 This specification allows for the use of recycled plastics (as defined in Guide D7209). 1.4 The values stated in inch-pound units are regarded as standard. The values in parentheses are for information only. 1.5 The following precautionary caveat pertains only to the test method portions of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
|
|
Standard Test Methods for Determining the Izod Pendulum Impact Resistance of Plastics
|
|
Standard Test Method for Tensile Properties of Plastics
|
|
Standard Test Methods for Flexural Properties of Unreinforced and Reinforced Plastics and Electrical Insulating Materials
|
LP-410A
|
Nylon Stock Shapes
|
|
Standard Practice for Packaging/Packing of Plastics
|
|
Standard Classification System for and Basis of Specification for Polyamide Molding and Extrusion Materials (PA)
|
|
Standard Guide for Waste Reduction, Resource Recovery, and Use of Recycled Polymeric Materials and Products (Withdrawn 2015)
|
|
Standard Terminology Relating to Plastics (Includes all amendments and changes 6/15/2026). |
Doporučujeme:
