Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ASTM D5930-97
Standard Test Method for Thermal Conductivity of Plastics by Means of a Transient Line-Source Technique
Automaticky přeložený název:
Standardní zkušební metoda pro tepelné vodivosti plastů pomocí Transient Line- Source Technika
NORMA vydána dne 10.3.2001
Informace o normě:
Označení normy: ASTM D5930-97
Poznámka: NEPLATNÁ
Datum vydání normy: 10.3.2001
Kód zboží: NS-33115
Počet stran: 5
Přibližná hmotnost: 15 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Anotace textu normy ASTM D5930-97 :
Keywords:
line-source probe, line-source technique, plastics, rubber-thermal conductivity, thermoplastics, thermosets, ICS Number Code 83.080.20 (Thermoplastic materials)
Doplňující informace
| Significance and Use | ||||||||||||||||
|
The relative simplicity of the test method makes it applicable for a wide range of materials (4, 5). The technique is capable of fast measurements, making it possible to take data before the materials suffer thermal degradation. Alternatively, it is possible to study the effect of compositional changes such as chemical reaction or aging (6). Short measurement times permit generation of large amounts of data with little effort. The line-source probe and the accompanying test specimen are small in size, making it possible to subject the sample to a wide range of test conditions. Because this test method does not contain a numerical precision and bias statement, it shall not be used as a referee test method in case of dispute. |
||||||||||||||||
| 1. Scope | ||||||||||||||||
|
1.1 This test method covers the determination of the thermal conductivity of plastics over a temperature range from -40 to 400oC. The thermal conductivity of materials in the range from 0.08 to 2.0 W/m.K can be measured covering thermoplastics, thermosets, and rubbers, filled and reinforced. 1.2 The values stated in SI units are to be regarded as standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Note 1--There is no current ISO document that duplicates this test method. |
||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||
|
Doporučujeme:
