Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Guide for Measuring Horizontal Positioning During Measurements of Surface Water Depths
Automaticky přeložený název:
Standardní Průvodce pro měření vodorovné poloze při měření povrchové vody hlubin
NORMA vydána dne 1.1.2013
Označení normy: ASTM D5906-02(2013)
Poznámka: NEPLATNÁ
Datum vydání normy: 1.1.2013
Kód zboží: NS-33038
Počet stran: 15
Přibližná hmotnost: 45 g (0.10 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
DGPS, GPS, RTK GPS, total station, transit, ICS Number Code 13.060.10 (Water of natural resources),17.020 (Metrology and measurement in general)
Significance and Use | ||||||||||||
5.1 This guide is intended to provide instructions for the selection of horizontal positioning equipment under a wide range of conditions encountered in measurement of water depth in surface water bodies. These conditions, that include physical conditions at the measuring site, the quality of data required, the availability of appropriate measuring equipment, and the distances over which the measurements are to be made (including cost considerations), that govern the selection process. A step-by-step procedure for obtaining horizontal position is not discussed. This guide is to be used in conjunction with standard guide on measurement of surface water depth (such as standard Practice D5173.) |
||||||||||||
1. Scope | ||||||||||||
1.1 This guide covers the selection of procedures commonly used to establish a measurement of horizontal position during investigations of surface water bodies that are as follows:
1.1.1 The narrative specifies horizontal positioning terminology and describes manual, optical, and electronic measuring equipment and techniques. 1.2 The references cited contain information that may help in the design of a high quality measurement program. 1.3 The information provided on horizontal positioning is descriptive in nature and not intended to endorse any particular item of manufactured equipment or procedure. 1.4 This guide pertains to determining horizontal position of a depth measurement in quiescent or low velocity flow. 1.5 The values stated in inch-pound units are to be regarded as the standard. The SI units in parentheses are for information only. 1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||
2. Referenced Documents | ||||||||||||
|
Poslední aktualizace: 23.12.2024 (Počet položek: 2 217 157)
© Copyright 2024 NORMSERVIS s.r.o.