ASTM D5878-19

4.1 The classification systems included in this standard and their respective applications are as follows:

4.2 Other classification systems are described in detail in the general references listed in the appendix.

4.3 Using this standard, the classifier shall be able to decide which system appears to be most appropriate for the specified engineering purpose at hand. The next step shall be the study of the source literature on the selected classification system and on case histories documenting the application of that system to real-world situations and the degree of success of each such application. Appropriate but by no means exhaustive references for this purpose are provided in the appendix and in STP 984 Note 3: The quality of the results produced by this standard is dependent on the competence of the personnel performing it, and the suitability of the equipment and facilities used. Agencies that meet the criteria of Practice D3740 are generally considered capable of competent and objective testing, sampling, inspection, etc. Users of this standard are cautioned that compliance with Practice D3740 does not in itself ensure reliable results. Reliable results depend on many factors. Practice D3740 provides a means for evaluating some of these factors.

1.1 These guides offer the selection of a suitable system of classification of rock mass for specific engineering purposes, such as tunneling and shaft-sinking, excavation of rock chambers, ground support, modification and stabilization of rock slopes, and preparation of foundations and abutments. These classification systems may also be of use in work on rippability of rock, quality of construction materials, and erosion resistance. Although widely used classification systems are treated in this standard, systems not included here may be more appropriate in some situations, and may be added to subsequent editions of this standard.

1.2 The valid, effective use of this standard is contingent upon the prior complete definition of the engineering purposes to be served and on the complete and competent definition of the geology and hydrology of the engineering site. Further, the person or persons using this standard shall have had field experience in studying rock-mass behavior. An appropriate reference for geotechnical mapping of large underground openings in rock is provided by Guide D4879.

1.3 This standard identifies the essential characteristics of seven classification systems. It does not include detailed guidance for application to all engineering purposes for which a particular system might be validly used. Detailed descriptions of the first five systems are presented in STP 984 1.4 The range of applications of each of the systems has grown since its inception. This standard summarizes the major fields of application up to this time of each of the seven classification systems.

1.5 The values stated in SI units are to be regarded as the standard. The values given in parentheses are mathematical conversions to inch-pounds units that are provided for information only and are not considered standard.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.7 This standard offers an organized collection of information or a series of options and does not recommend a specific course of action. This document cannot replace education ore experience and shall be used in conjunction with professional judgement. Not all aspects of this standard may be applicable in all circumstances. This ASTM standard is not intended to represent or replace the standard of care by which the adequacy of a given professional service must be judged, nor shall this document be applied without consideration of a project's many unique aspects. The word “Standard” in the title of this document means only that the document has been approved through the ASTM consensus process.

1.8 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.