Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ASTM D5813-04(2008)
Standard Specification for Cured-In-Place Thermosetting Resin Sewer Piping Systems
Automaticky přeložený název:
Standardní specifikace pro Vytvrzený -In -Place Teplem Plastové kanalizační potrubí Systems
NORMA vydána dne 15.12.2008
Informace o normě:
Označení normy: ASTM D5813-04(2008)
Poznámka: NEPLATNÁ
Datum vydání normy: 15.12.2008
Kód zboží: NS-32659
Počet stran: 4
Přibližná hmotnost: 12 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Anotace textu normy ASTM D5813-04(2008) :
Keywords:
cured-in-place pipe (CIPP), plastic pipe´thermoset, rehabilitation, thermosetting resin pipe, underground installation, Curing (in pipeline/conduit rehabilitation), Sewer pipe (thermoplastic)--specifications, Thermosetting plastic pipe/tubing/fittings--specifications
Doplňující informace
| 1. Scope | ||||||||||||||||||||||||||||||
|
1.1 This specification covers cured-in-place thermosetting resin pipe (CIPP), 4 through 132-in. (100 through 3353-mm) equivalent diameter, for use in gravity flow systems for conveying sanitary sewage, storm water, and certain industrial wastes. This specification is suited for the evaluation and testing of materials used in the rehabilitation of existing pipes by the installation and cure of a resin-impregnated fabric liner. 1.2 This specification can also be extended to cover manholes, pump stations, wetwells, vaults, storage tanks, and other similar structures where a cured in place liner using thermosetting resin is applicable. 1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. Note 1—There are no ISO standards covering the primary subject matter of this specification. 1.4 The following safety hazards caveat pertains only to the test methods portion, Section 8, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||||||||||||||||
|
Doporučujeme:
