ASTM D5630-22

5.1?Inorganic residues from plastics ashing may be antiblock, fillers, reinforcements, catalyst residues, colorants, etc. The quantitative amounts of each are important variables of the manufacturing process.

1.1?This test method was developed to determine the inorganic content of plastics by destructive ashing procedures. Ash levels of 0.01 % or above are covered by this test method.

1.2?These ashing procedures are used only to quantify the residual solids in the polymer and can not be used to identify the individual chemical components of the ash, qualitatively.

1.3?This test method is limited to those materials (including glass) that are stable to 900?C. Test Method D2584 is recommended for unknown samples, and in instances where fusion of the inorganic portions may be of concern.

1.4?Fluorinated polymers and polymers containing halogenated components have not been included in these procedures.

1.5?Two procedures for determining the inorganic residue in plastics are listed as follows:

1.6?The values stated in SI units are to be regarded as the standard.

1.7?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.8?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.