ASTM D5493-23

5.1?The thickness of a geotextile decreases with increase in the normal compressive stress. This decrease in thickness may result in the partial closing or the opening of the voids of geotextile depending on its initial structure and the boundary conditions.

5.2?This test method measures the permittivity due to a change of void structure of a geotextile as a result of an applied compressive stress.

1.1?This test method covers the determination of the water permittivity behavior of geotextiles in a direction normal to the plane of the geotextile when subjected to specific normal compressive loads.

1.2?Use of this test method is limited to geotextiles. This test method is not intended for application with geotextile-related products such as geogrids, geonets, geomembranes, and other geocomposites.

1.3?The values stated in SI units are to be regarded as the standard. The inch-pound units given in parentheses are for information only.

1.4?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.