Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Windload Resistance of Rigid Plastic Siding
Automaticky přeložený název:
Standardní zkušební metoda pro Windload Odolnost tuhého plastu Siding
NORMA vydána dne 1.1.2013
Označení normy: ASTM D5206-13
Poznámka: NEPLATNÁ
Datum vydání normy: 1.1.2013
Kód zboží: NS-30276
Počet stran: 4
Přibližná hmotnost: 12 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
PVC siding, plastic siding, siding failure modes, test methods, windload resistance, ICS Number Code 91.060.10 (Walls. Partitions. Facades)
Significance and Use | ||||||||||
5.1 This test method is a standard procedure for determining windload resistance of rigid plastic siding under specified uniform static pressure difference. This typically is intended to represent the effects of wind loads on exterior building surfaces. The actual loading on building surfaces is quite complex, varying with wind direction, time, height above ground, building shape, terrain, surrounding structures, and other factors. 5.2 Design wind pressure is selected for specific geographical locations from wind velocity maps prepared by the National Weather Service or other sources. Refer to Annex A1 of Specification D3679 for additional detailed information relating to use of this test method for evaluation of rigid poly(vinyl chloride) (PVC) siding. 1.1 This test method describes
methods for testing and evaluating windload resistance of rigid
plastic siding when fastened in accordance with Practice D4756.
1.2 The proper use of this test method requires a knowledge of the principles of pressure measurement. 1.3 This test method describes the apparatus and the procedures to be used to determine an average maximum sustained static test pressure, or ultimate test pressure values, or both, with static pressure applied uniformly to a specimen. 1.4 The values expressed in
inch-pound units are to be regarded as the standard. The SI
equivalents in parentheses are for information only.
1.5 This standard does not
purport to address all of the safety concerns, if any, associated
with its use. It is the responsibility of the user of this standard
to establish appropriate safety and health practices and determine
the applicability of regulatory limitations prior to use.
Standard Terminology Relating to
Plastics Standard Terminology for Abbreviated
Terms Relating to Plastics (Withdrawn 2024) Standard Specification for Rigid
Poly(Vinyl Chloride) (PVC) Siding Standard Practice for Installation of
Rigid Poly(Vinyl Chloride) (PVC) Siding and Soffit Standard Terminology of Building
Constructions |
Historická
1.5.2011
Historická
1.4.2007
Historická
1.1.2012
Historická
1.11.2013
Historická
1.4.2011
Historická
1.4.2009
Poslední aktualizace: 22.11.2024 (Počet položek: 2 206 568)
© Copyright 2024 NORMSERVIS s.r.o.