Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Resin Solution Dilutability by Volumetric/Gravimetric Determination
Automaticky přeložený název:
Standardní zkušební metoda pro roztok pryskyřice ředitelnost objemovým / gravimetrické stanovení
NORMA vydána dne 1.3.2009
Označení normy: ASTM D5062-09
Poznámka: NEPLATNÁ
Datum vydání normy: 1.3.2009
Kód zboží: NS-29694
Počet stran: 3
Přibližná hmotnost: 9 g (0.02 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
dilutability value, percent dilutability, printing ink resins, resins, resin solution cloud point, resin solution dilutability, solvent tolerance, Dilutability value, Gravimetric determination, Percent dilutability, Printing ink resins, Printing inks/vehicles, Resins, Resin solution cloud point, Resin solutions, Solubility, Solvent tolerance, Titrimetric method, Turbidity, ICS Number Code 87.060.20 (Binders)
Significance and Use | ||||
This test method provides a means for resin producers and users as well as solvent and varnish manufacturers to rate various types of resins for solubility by assigning a numerical dilutability value. This percent dilutability value can be used to differentiate resin types for end users and can be utilized as a quality control tool by resin manufacturers. When running a series of these tests, the same lot or batch of dilution solvent must be used throughout to ensure reproducible results. |
||||
1. Scope | ||||
1.1 This test method covers both volumetric and gravimetric determination of resin solution dilutability which gives a numerical value for the overall solubility of the resin expressed as percent dilutability. 1.2 This test method is applicable only if the test solution is of sufficient clarity to allow accurate visual judgement of the end point and of low enough viscosity for efficient mixing to take place. 1.3 This test method is primarily for, but not limited to, resins used in the printing ink industry. 1.4 The percent solvent tolerance of a resin can be determined using this test method if the solvent in the resin solution and the dilution solvent are the same. 1.5 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||
2. Referenced Documents | ||||
|
Historická
1.7.2010
Historická
1.6.2010
Historická
1.6.2011
Historická
1.11.2006
Historická
1.12.2010
Historická
1.12.2009
Poslední aktualizace: 15.09.2024 (Počet položek: 2 433 670)
© Copyright 2024 NORMSERVIS s.r.o.