Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Carbon Dioxide in Natural Gas Using Length-of-Stain Detector Tubes
Automaticky přeložený název:
Standardní testovací metoda pro oxid uhličitý se zemním plynem Použití Délka-of-Stain detekčními trubičkami
NORMA vydána dne 1.11.2015
Označení normy: ASTM D4984-06(2015)
Poznámka: NEPLATNÁ
Datum vydání normy: 1.11.2015
Kód zboží: NS-622636
Počet stran: 3
Přibližná hmotnost: 9 g (0.02 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
gaseous fuels, natural gas ,, ICS Number Code 75.160.30 (Gaseous fuels)
Significance and Use | ||
5.1 The measurement of carbon dioxide in natural gas is important, because of the gas quality specifications, the corrosive nature of carbon dioxide on pipeline materials, and the affects of carbon dioxide on utilization equipment. 5.2 This test method provides inexpensive field screening of carbon dioxide. The system design is such that it may be used by nontechnical personnel with a minimum of proper training. |
||
1. Scope | ||
1.1 This test method covers a rapid and simple field determination of carbon dioxide in natural gas pipelines. Available detector tubes provide a total measuring range of 100 ppm (parts per million) up to 60 % by volume, although the majority of applications will be on the lower end of this range (that is, under 5 %). At least one manufacturer provides a special kit for measurements from 10 to 100 % CO2, but the normal 100-cc hand pump is not used. See Note 1. Note 1: High-range carbon dioxide detector tubes will have
measuring ranges in percent (%) CO2, and low-range tubes will be in
parts per million (ppm). To convert percent to ppm, multiply by
10 000 (1 % = 10 000 ppm).
1.2 The values stated in SI units are regarded as standard. The inch-pound units in parentheses are for information only. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||
2. Referenced Documents | ||
|
Poslední aktualizace: 28.04.2024 (Počet položek: 2 896 137)
© Copyright 2024 NORMSERVIS s.r.o.