Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ASTM D4806-11a
Standard Specification for Denatured Fuel Ethanol for Blending with Gasolines for Use as Automotive Spark-Ignition Engine Fuel (Includes all amendments And changes 2/25/2013).
Automaticky přeložený název:
Standardní specifikace pro denaturovaného ethanolu palivové pro smíchání s gasolines pro použití jako Automotive zážehového motoru Palivo
NORMA vydána dne 1.6.2011
Informace o normě:
Označení normy: ASTM D4806-11a
Poznámka: NEPLATNÁ
Datum vydání normy: 1.6.2011
Kód zboží: NS-28664
Počet stran: 7
Přibližná hmotnost: 21 g (0.05 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Anotace textu normy ASTM D4806-11a :
Keywords:
acidity, automotive spark-ignition engine fuel, base gasoline, chloride ion, copper, corrosion inhibitors, denaturants, denatured fuel ethanol, ethanol, fuel, fuel ethanol, gasoline, gasoline-ethanol blend, oxygenate, solvent-washed gum content, sulfate ion, sulfur, water, Automotive engine fuels/oils--specifications, Ethanol, Fuel oils--specifications, Gas chromatography (GC)--petroleum products, Gaseous fuels--specifications, Petroleum products--specifications, Prohibited denaturants
Doplňující informace
| 1. Scope | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
1.1 This specification covers nominally anhydrous denatured fuel ethanol intended to be blended with unleaded or leaded gasolines at 1 to 10 volume % for use as automotive spark-ignition engine fuel covered by Specification D4814. The significance of this specification is shown in Appendix X1. 1.2 The user is advised to check with the national regulatory agencies where the ethanol is denatured and used. The sulfur limit and denaturing formulas in this specification are acceptable for the U.S. market. Other countries or jurisdictions may allow or require other denaturing formulas and sulfur limits. 1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.4 The following safety hazards caveat pertains only to the method modification in 8.7 of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
Doporučujeme:
