Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ASTM D471-98e1
Standard Test Method for Rubber Property-Effect of Liquids (Includes all amendments And changes 8/16/2017).
Automaticky přeložený název:
Standardní zkušební metoda pro Rubber Property efekt kapalin
NORMA vydána dne 28.9.1999
Informace o normě:
Označení normy: ASTM D471-98e1
Poznámka: NEPLATNÁ
Datum vydání normy: 28.9.1999
Kód zboží: NS-28259
Počet stran: 13
Přibližná hmotnost: 39 g (0.09 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Anotace textu normy ASTM D471-98e1 :
Keywords:
elevated temperature, fluid immersion, liquid immersion, reference fuel, rubber articles, rubber products, service liquid, ICS Number Code 83.060 (Rubber)
Doplňující informace
| 1. Scope | ||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
1.1 This test method covers the required procedures to evaluate the comparative ability of rubber and rubber-like compositions to withstand the effect of liquids. It is designed for testing: (1) specimens of vulcanized rubber cut from standard sheets (see Practice D 3182), (2) specimens cut from fabric coated with vulcanized rubber (see Test Method D 751), or (3) finished articles of commerce (see Practice D 3183). This test method is not applicable to the testing of cellular rubbers, porous compositions, and compressed sheet packing, except as described in 11.2.2. 1.2 ASTM Oils No. 2 and No. 3, formerly used in this test method as standard test liquids, are no longer commercially available and in 1993 were replaced with IRM 902 and IRM 903, respectively (see Appendix 1 for details). 1.3 This test method includes the following: Change in Mass (after immersion) Section 10 Change in Volume (after immersion) Section 11 Dimensional-Change Method for Water-Insoluble Liquids and Mixed Liquids Section 12 Change in Mass with Liquid on One Surface Only Section 13 Determining Mass of Soluble Matter Extracted by the Liquid Section 14 Change in Tensile Strength, Elongation and Hardness (after immersion) Section 15 Change in Breaking Resistance, Burst Strength, Tear Strength and Adhesion for Coated Fabrics Section 16 Calculation (of test results) Section 171.4 The values stated in SI units are to be regarded as the standard. The values in parentheses are for information only. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||||||||||||||||||||||||||||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
Doporučujeme:
