Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Methods for Acid Number of Pine Chemical Products Including Tall Oil and Other Related Products
Přeložit název
NORMA vydána dne 1.6.2020
Označení normy: ASTM D465-15(2020)
Datum vydání normy: 1.6.2020
Kód zboží: NS-997593
Počet stran: 4
Přibližná hmotnost: 12 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
acid number, rosin, tall oil, tall oil fatty acids,, ICS Number Code 87.060.20 (Binders)
Significance and Use | ||||||||||
3.1 These test methods are designed to broaden the scope of the earlier editions of the test method by the inclusion of tall oil and tall oil derived products as test materials and will be referenced in Test Methods D803. 3.2 The acid number is an important property of pine chemical products, such as tall oil, and the products obtained by the fractionation of tall oil. It is the test method widely used to determine the total free acid content of these products. 3.3 The potentiometric test method should be used when the most reproducible results are required. |
||||||||||
1. Scope | ||||||||||
1.1 These test methods are intended for determining the acid number of pine chemical products as defined in Terminology D804 including tall oil products, wood and gum rosin, and other related materials. These test methods may not be applicable to all modified rosin products. Two test methods are covered, as follows: 1.1.1 Potentiometric method (referee), and 1.1.2 Internal indicator method (alternate). 1.2 The potentiometric method is suitable for use with both light- and dark-colored products. It should be considered the referee method. The internal indicator method is suitable for use only with light- and medium-colored products with a Gardner color of less than 12. It should be considered the alternate method. 1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||
2. Referenced Documents | ||||||||||
|
Poslední aktualizace: 03.11.2024 (Počet položek: 2 209 203)
© Copyright 2024 NORMSERVIS s.r.o.