Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Practice for Measuring the Concentration of Toxic Gases or Vapors Using Length-of-Stain Dosimeters (Includes all amendments And changes 10/6/2014).
Automaticky přeložený název:
Standardní praxe pro měření koncentrace toxických plynů a par Použití Délka - of- Stain dozimetrů
NORMA vydána dne 1.10.2009
Označení normy: ASTM D4599-03(2009)e1
Poznámka: NEPLATNÁ
Datum vydání normy: 1.10.2009
Kód zboží: NS-27852
Počet stran: 4
Přibližná hmotnost: 12 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
air monitoring, colorimetric dosimeter tubes, diffusional sampling, dosimeter tubes, sampling and analysis, toxic gases and vapors, workplace atmospheres, Atmospheric analysis, Colorimetric analysis--atmospheric, Concentration (of elements), Dosimetry, Gases (atmospheric), Health hazards, Length-of-stain dosimetry, Occupational health and safety--atmospheric, Organic compounds--atmospheric, Sampling air/atmospheric materials/applications, Vapor phase analysis/processing--atmospheric
Significance and Use | ||||
The U.S. Occupational Safety and Health Administration (OSHA) in 29 CFR 1910.1000 Subpart Z designates that certain gases and vapors present in work place atmospheres must be controlled so that their concentrations do not exceed specified limits. Other countries have similar regulations. This practice will provide a means for the determination of airborne concentrations of certain gases and vapors listed in 29 CFR 1910.1000 and in other countries’ regulations. A partial list of chemicals for which this practice is applicable is presented in Annex A1 with current Threshold Limit Values (TLV) (2) and typical measurement ranges for the selected chemicals as obtained from various manufacturer's specifications. This practice may be used for either personal or area monitoring. |
||||
1. Scope | ||||
1.1 This practice describes the detection and measurement of time weighted average (TWA) concentrations of toxic gases or vapors using length-of-stain colorimetric dosimeter tubes. A list of some of the gases and vapors that can be detected by this practice is provided in Annex A1. This list is given as a guide and should be considered neither absolute nor complete. 1.2 Length-of-stain colorimetric dosimeters work by diffusional sampling. The results are immediately available by visual observation; thus no auxiliary sampling, test nor analysis equipment are needed. The dosimeters, therefore, are extremely simple to use and very cost effective. 1.3 The values stated in SI units shall be regarded as the standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||
2. Referenced Documents | ||||
|
Chcete mít jistotu, že používáte pouze platné technické normy?
Nabízíme Vám řešení, které Vám zajistí měsíční přehled o aktuálnosti norem, které používáte.
Chcete vědět více informací? Podívejte se na tuto stránku.
Poslední aktualizace: 15.05.2024 (Počet položek: 2 900 316)
© Copyright 2024 NORMSERVIS s.r.o.