ASTM D4354-12(2020)

5.1 This practice provides a means by which samples of geosynthetics may be selected to provide a statistically valid sample for the selection of test specimens without previous knowledge of the variability that may exist between production units.

5.2 The principles stated in Practice D4271, and the illustrative text in that practice, can be used by test method authors in preparing sampling statements.

5.3 This practice gives three procedures for sampling: one for manufacturer's quality control (MQC), one for manufacturer's quality assurance (MQA) testing, and a third for purchaser's specification conformance testing. For this reason, test methods containing a section on sampling that requires the use of this practice should contain a statement in the section on reporting similar to the following: “Report which procedure from Practice D4354 was used for sampling: Procedure A for Manufacturer's Quality Control (MQC), Procedure B for Manufacturer's Quality Assurance (MQA) Testing, or Procedure C for Purchaser's Specification Conformance Testing.

5.4 Manufacturer's quality assurance is done internally to assure the manufacturer of the MQC program. When it is required to provide certification to a purchaser as to quality assurance, the MQA testing is to be done by an external MQA testing facility.

1.1 This practice covers three procedures for the sampling of geosynthetics and rolled erosion control products (RECPs) for testing. This practice requires that instructions on taking laboratory samples and test specimens be part of every test method for geosynthetics.

1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.