Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ASTM D4315-21
Standard Test Methods for Rubber Compounding Material—Zinc Oxide
Přeložit název
NORMA vydána dne 1.11.2021
Informace o normě:
Označení normy: ASTM D4315-21
Datum vydání normy: 1.11.2021
Kód zboží: NS-1042199
Počet stran: 3
Přibližná hmotnost: 9 g (0.02 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Kategorie - podobné normy:
Anotace textu normy ASTM D4315-21 :
Keywords:
chemical and physical tests for zinc oxide, heat loss, lead and cadmium in zinc oxide, sieve residue, sulfur in zinc oxide, surface area, zinc oxide, zinc oxide percent,, ICS Number Code 83.040.20 (Rubber compounding ingredients)
Doplňující informace
| Significance and Use | |||||||||||||||
|
3.1?These test methods may be used for quality control of zinc oxide used as a compounding material and for research and development studies where zinc oxide is used in a rubber mix. |
|||||||||||||||
| 1. Scope | |||||||||||||||
|
1.1?These test methods cover chemical and physical tests for zinc oxide that are considered to be important to its use in rubber compounding. 1.2?The tests appear in the following order:
1.3?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
|||||||||||||||
| 2. Referenced Documents | |||||||||||||||
|
Doporučujeme:
