Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for High-Shear Viscosity Using a Cone/Plate Viscometer
Automaticky přeložený název:
Standardní zkušební metoda pro viskozita při vysoké smykové Použití kužel / Plate Viscometer
NORMA vydána dne 1.2.2010
Označení normy: ASTM D4287-00(2010)
Poznámka: NEPLATNÁ
Datum vydání normy: 1.2.2010
Kód zboží: NS-26682
Počet stran: 3
Přibližná hmotnost: 9 g (0.02 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
viscosity-paints/related coatings/materials, viscometer-ICI cone/plate , viscometer-cone/plate, Application viscosity (for paints/related products), Cone-and-plate viscometers, Flow and flow rate--paints/related coatings/materials, ICI cone/plate viscometers, Latex paints, Varnishes, Viscosity--paints/related coatings/materials, Viscosity at high shear, ICS Number Code 87.040 (Paints and varnishes)
Significance and Use | ||||||
The viscosity value obtained by this test method gives information about the flow properties of the material under high-shear conditions similar to those encountered during application: brushing (see Test Method D 4958), spraying, electrostatic disk, or roll coating. This test method is suitable for all paints and varnishes whether they are Newtonian in behavior or not. However, due to the narrow gap between the stationary and rotary parts of high-shear viscometers, this test method is more reproducible for paints having finer pigment dispersions as determined by Test Method D 1210. |
||||||
1. Scope | ||||||
1.1 This test method covers the determination of the viscosity of paints, varnishes, and related products at a rate of shear of 12 000 s−1. 1.2 Paints and varnishes that dry very rapidly may not give reproducible results with this test method. Measurements made at elevated temperatures may also give poor precision due to loss of volatiles and to drying. 1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||
2. Referenced Documents | ||||||
|
Chcete mít jistotu, že používáte pouze platné technické normy?
Nabízíme Vám řešení, které Vám zajistí měsíční přehled o aktuálnosti norem, které používáte.
Chcete vědět více informací? Podívejte se na tuto stránku.
Poslední aktualizace: 22.11.2024 (Počet položek: 2 206 568)
© Copyright 2024 NORMSERVIS s.r.o.