Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Scrub Resistance of Paints by Abrasion Weight Loss
Automaticky přeložený název:
Standardní zkušební metoda pro odolnost proti oděru barev broušením hubnutí
NORMA vydána dne 1.7.2012
Označení normy: ASTM D4213-08(2012)
Poznámka: NEPLATNÁ
Datum vydání normy: 1.7.2012
Kód zboží: NS-26445
Počet stran: 5
Přibližná hmotnost: 15 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
abrasion resistance, resistance/abrasion/wet abrasion/scrub, scrub resistance, washability, wet abrasion resistance, ICS Number Code 87.040 (Paints and varnishes)
Significance and Use | ||||||||||||||||||||
4.1 Interior paint films often become soiled, especially near doorways, windows, and play areas, and frequently need to be cleaned by scrubbing. This test method covers the determination of the relative resistance of paints to erosion when scrubbed. 4.2 The precision of scrub resistance measurements in absolute physical values, such as Test Methods D2486 cycles-to-failure or this test method, microlitres per 100 cycles, is poor due to the relatively large effect of subtle and difficult-to-control variables in test conditions. The test method described herein minimizes this problem by using a standard calibration panel as an integral part of each scrubbing operation and relating its weight loss to that of the paint film under test to establish the latter's scrub resistance. 4.3 Results obtained by this test
method do not necessarily represent the scrub resistance that might
be determined if the test film is allowed to dry before testing
appreciably longer than the seven-day period specified herein.
4.4 Results obtained by this test method do not necessarily relate to ease of soil or stain removal (also referred to as “cleanability” or “cleansability”). To test for those characteristics use Test Methods D3450 and D4828. FIG. 1 Alignment of Panels for
Scrubbing
|
||||||||||||||||||||
1. Scope | ||||||||||||||||||||
1.1 This test method covers an accelerated procedure for determining the resistance of paints to erosion caused by scrubbing. (Note: The term wet abrasion is sometimes used for scrubbing, and 1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||||
|
Historická
1.7.2013
Historická
1.7.2010
Historická
1.6.2011
Historická
1.11.2011
Historická
1.2.2012
Historická
1.11.2013
Poslední aktualizace: 22.11.2024 (Počet položek: 2 206 568)
© Copyright 2024 NORMSERVIS s.r.o.