Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Methods for Vulcanized Rubber and Thermoplastic Elastomers—Tension (Includes all amendments And changes 1/21/2016).
Automaticky přeložený název:
Standardní zkušební metody pro vulkanizovaného kaučuku a termoplastické elastomery & ndash; napínací
NORMA vydána dne 1.1.2013
Označení normy: ASTM D412-06a(2013)
Poznámka: NEPLATNÁ
Datum vydání normy: 1.1.2013
Kód zboží: NS-26113
Počet stran: 14
Přibližná hmotnost: 42 g (0.09 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
elongation, set after break, tensile properties, tensile set, tensile strength, tensile stress, yield point, ICS Number Code 83.060 (Rubber)
Significance and Use | ||||||||||||||||||
5.1 All materials and products covered by these test methods must withstand tensile forces for adequate performance in certain applications. These test methods allow for the measurement of such tensile properties. However, tensile properties alone may not directly relate to the total end use performance of the product because of the wide range of potential performance requirements in actual use. 5.2 Tensile properties depend both on the material and the conditions of test (extension rate, temperature, humidity, specimen geometry, pretest conditioning, etc.); therefore materials should be compared only when tested under the same conditions. 5.3 Temperature and rate of extension may have substantial effects on tensile properties and therefore should be controlled. These effects will vary depending on the type of material being tested. 5.4 Tensile set represents residual deformation which is partly permanent and partly recoverable after stretching and retraction. For this reason, the periods of extension and recovery (and other conditions of test) must be controlled to obtain comparable results. |
||||||||||||||||||
1. Scope | ||||||||||||||||||
1.1 These test methods cover procedures used to evaluate the tensile (tension) properties of vulcanized thermoset rubbers and thermoplastic elastomers. These methods are not applicable to ebonite and similar hard, low elongation materials. The methods appear as follows:
1.2 The values stated in either SI
or non-SI units shall be regarded separately as normative for this
standard. The values in each system may not be exact equivalents;
therefore each system must be used independently, without combining
values.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||
|
Historická
1.5.2011
Historická
1.5.2014
Historická
1.5.2010
Historická
1.5.2012
Historická
1.5.2012
Historická
1.7.2009
Poslední aktualizace: 22.11.2024 (Počet položek: 2 206 568)
© Copyright 2024 NORMSERVIS s.r.o.