Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Specification for Contact-Molded Glass-Fiber-Reinforced Thermoset Resin Corrosion-Resistant Tanks
Automaticky přeložený název:
Standard Specification pro Contact-lisovaného skla, z vyztužených Termosetovou pryskyřice odolné proti korozi nádrže
NORMA vydána dne 1.1.2010
Označení normy: ASTM D4097-01(2010)
Poznámka: NEPLATNÁ
Datum vydání normy: 1.1.2010
Kód zboží: NS-26018
Počet stran: 16
Přibližná hmotnost: 48 g (0.11 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
above ground, atmosphere, contact-molded, polyester, vinylester, Aboveground storage tanks, Chemical resistance--plastics, Chemical-resistant nonmetallic materials, Containers--tanks, Corrosive service applications--plastics, Cylindrical tanks, Glass-fiber-reinforced (GRP) plastics--specifications, Installation--plastic pipe materials/applications, Joint construction, Laminates--plastic, Liquid environments, Outdoor service equipment, Plastics--glass-fiber reinforced products
1. Scope | ||||||||||||||||||||||||||||||||
1.1 This specification covers cylindrical tanks fabricated by contact molding for above-ground vertical installation, to contain aggressive chemicals at essentially atmospheric pressure, and made of a commercial-grade polyester or vinyl ester, resin. Included are requirements for materials, properties, design, construction, dimensions, tolerances, workmanship, and appearance. 1.2 This specification does not cover the design of vessels intended for pressure above hydrostatic, vacuum conditions, except as classified herein, or vessels intended for use with liquids heated above their flash points. 1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are provided for information purposes only. Note 1—Special design consideration should be given to vessels subject to superimposed mechanical forces, such as earthquakes, wind load, or agitation, to vessels subject to service temperature in excess of 180°F (82°C), and to vessels with unsupported bottoms. Note 2—There is no known ISO equivalent to this standard. 1.4 The following safety hazards caveat pertains only to the test method portion, Section 11, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||||||||||||||||
|
Historická
1.10.2013
Historická
1.4.2010
Historická
1.4.2013
Historická
1.7.2011
Historická
15.6.2012
Historická
15.6.2012
Chcete pravidelně odebírat informace o nově vycházejících normách z celého světa a to zcela zdarma?
Přihlašte se k odběru. Vše je velice jednoduché a absolutně ZDARMA.
Na výběr máte vydavatele z celého světa.
Poslední aktualizace: 22.12.2024 (Počet položek: 2 217 000)
© Copyright 2024 NORMSERVIS s.r.o.