Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ASTM D3895-14
Standard Test Method for Oxidative-Induction Time of Polyolefins by Differential Scanning Calorimetry
Automaticky přeložený název:
Standardní zkušební metoda pro oxidační-Indukční doba polyolefinů diferenční skenovací kalorimetrií
NORMA vydána dne 1.12.2014
Informace o normě:
Označení normy: ASTM D3895-14
Poznámka: NEPLATNÁ
Datum vydání normy: 1.12.2014
Kód zboží: NS-25264
Počet stran: 8
Přibližná hmotnost: 24 g (0.05 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Kategorie - podobné normy:
Anotace textu normy ASTM D3895-14 :
Keywords:
differential scanning calorimetry, oxidative induction time, polyolefins,, ICS Number Code 83.080.20 (Thermoplastic materials)
Doplňující informace
| Significance and Use | ||||||||
|
5.1 The OIT is a qualitative assessment of the level (or degree) of stabilization of the material tested. This test has the potential to be used as a quality control measure to monitor the stabilization level in formulated resin as received from a supplier, prior to extrusion. Note 2: The OIT measurement is an accelerated thermal-aging
test and as such can be misleading. Caution should be exercised in
data interpretation since oxidation reaction kinetics are a
function of temperature and the inherent properties of the
additives contained in the sample. For example, OIT results are
often used to select optimum resin formulations. Volatile
antioxidants may generate poor OIT results even though they may
perform adequately at the intended use temperature of the finished
product.
Note 3: There is no accepted sampling procedure, nor have any
definitive relationships been established for comparing OIT values
on field samples to those on unused products, hence the use of such
values for determining life expectancy is uncertain and
subjective.
|
||||||||
| 1. Scope | ||||||||
|
1.1 This test method outlines a procedure for the determination of oxidative-induction time (OIT) of polymeric materials by differential scanning calorimetry (DSC). It is applicable to polyolefin resins that are in a fully stabilized/compounded form. 1.2 The values stated in SI units are to be regarded as the standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazards information is given in Section 8. Note 1: This standard and ISO 11357–6 2013 address the same
subject matter, but differ in technical content.
|
||||||||
| 2. Referenced Documents | ||||||||
|
Doporučujeme:
EviZak - všechny zákony včetně jejich evidence na jednom místě
Poskytování aktuálních informací o legislativních předpisech vyhlášených ve Sbírce zákonů od roku 1945.
Aktualizace 2x v měsíci !
Chcete vědět více informací? Podívejte se na tuto stránku.
