Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Retention Characteristics of 0.2-µm Membrane Filters Used in Routine Filtration Procedures for the Evaluation of Microbiological Water Quality
Automaticky přeložený název:
Standardní zkušební metoda pro uchovávání informací Charakteristika 0,2 um Membránové filtry používané v rutinním filtrace postupy pro hodnocení mikrobiologických kvality vody
NORMA vydána dne 15.2.2013
Označení normy: ASTM D3862-13
Poznámka: NEPLATNÁ
Datum vydání normy: 15.2.2013
Kód zboží: NS-25131
Počet stran: 3
Přibližná hmotnost: 9 g (0.02 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
filters, membrane, microbiological, retention, ICS Number Code 07.100.20 (Microbiology of water)
Significance and Use | ||||
5.1 Microbiological water testing procedures using membrane filtration are based on the premise that all bacteria within a specific size range will be retained by the membrane filter used. If the membrane filter does not retain these bacteria, false negative results or lowered density estimates may occur that could have serious repercussions due to the presence of unrecognized potential health hazards in the water being tested, especially in drinking water. 5.1.1 This procedure as devised will enable the user to test each membrane filter lot number for its ability to retain all bacterial equal to, or larger than, the stated membrane pore size. 5.2 Since this membrane is often used to sterilize nonautoclavable liquids, it is essential that the retention characteristics of this membrane are stable. |
||||
1. Scope | ||||
1.1 This test method covers a procedure to test membrane filters for their ability to retain bacteria whose diameter is equal to or slightly larger than the 0.2-µm pore size of the membrane filter. 1.2 The procedures described are for the use of user laboratories as differentiated from manufacturers' laboratories. 1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||
2. Referenced Documents | ||||
|
Historická
1.12.2012
Historická
1.12.2012
Historická
1.3.2013
Historická
1.3.2013
Historická
1.12.2012
Historická
1.9.2010
Poslední aktualizace: 26.04.2024 (Počet položek: 2 896 057)
© Copyright 2024 NORMSERVIS s.r.o.