Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Practice for Determination of Adsorptive Capacity of Activated Carbon by Aqueous Phase Isotherm Technique
Přeložit název
NORMA vydána dne 1.6.2020
Označení normy: ASTM D3860-98(2020)
Datum vydání normy: 1.6.2020
Kód zboží: NS-994970
Počet stran: 3
Přibližná hmotnost: 9 g (0.02 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
activated carbon,, ICS Number Code 71.060.10 (Chemical elements)
Significance and Use | ||||||||||||
5.1 This practice is used when activated carbon is considered as an adsorbent in treating water. Since both granular and powdered activated carbons are commercially available, a standard practice is needed to ensure that the activated carbons are evaluated under the same test conditions. Specified particle size carbon is to be used to ensure that the same test conditions are used. The practice is generally performed at 20 °C; however, other temperatures may be used and noted. |
||||||||||||
1. Scope | ||||||||||||
1.1 This practice covers the determination of the adsorptive capacity of activated carbon to remove undesirable constituents from water and waste water. It can be used to evaluate the adsorptive capacity of activated or reactivated carbon. 1.2 This practice is not recommended unless special precautions are taken to reduce loss during sample preparation and analysis. 1.3 This practice is recommended to determine the adsorptive capacity of activated carbon for the following applications, but is not limited to these applications: 1.3.1 Removal of color from dye mill waste water, 1.3.2 Removal of taste or odor constituents, or both, from potable waters, 1.3.3 Removal of toxicants from water, 1.3.4 Removal of surface-active agents from water, 1.3.5 Removal of BOD5 from sanitary waste waters, and 1.3.6 Removal of TOC from industrial waste waters. 1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||
2. Referenced Documents | ||||||||||||
|
Chcete mít jistotu o platnosti užívaných předpisů?
Nabízíme Vám řešení, abyste mohli používat stále platné (aktuální) legislativní předpisy.
Chcete vědět více informací? Podívejte se na tuto stránku.
Poslední aktualizace: 26.11.2024 (Počet položek: 2 206 223)
© Copyright 2024 NORMSERVIS s.r.o.