Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Qualitative Determination of Adhesion of Adhesives to Substrates by Spot Adhesion
Automaticky přeložený název:
Standardní zkušební metody pro kvalitativní stanovení adheze lepidel na substráty Spot Adheze
NORMA vydána dne 1.7.2013
Označení normy: ASTM D3808-01(2013)
Poznámka: NEPLATNÁ
Datum vydání normy: 1.7.2013
Kód zboží: NS-24945
Počet stran: 2
Přibližná hmotnost: 6 g (0.01 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
hot melt adhesive, spot adhesion, structural adhesive, ICS Number Code 83.180 (Adhesives)
Significance and Use | ||||
5.1 This is a quick, simple, and inexpensive test method for qualitatively determining, without the need to prepare bonded test specimens, whether the adhesive under consideration will bond to a particular substrate. If the results are acceptable, then standard quantitative adhesive test procedures can be used to obtain quantitative measurements of the adhesive's performance. 5.2 This test method can also be used to compare relative adhesion of several adhesives to given substrates. 5.3 It can be used to determine whether an adhesive will continue to adhere to the substrate under specified environmental conditions. 5.4 It can be used to evaluate adhesion of a particular adhesive to a variety of substrates. 5.5 It can be used to obtain “subjective” comparative data between several adhesives on a given substrate by noting the relative ease of inducing failure between the adhesives tested. 5.6 It should be most applicable to adhesives that cure or set when exposed to “air” (ambient, heated, etc.) and could be used for anaerobic adhesives if testing is carried out in an oxygen-free atmosphere. |
||||
1. Scope | ||||
1.1 This test method covers a simple qualitative procedure for quickly screening whether an adhesive will, under recommended application conditions, bond to a given substrate without actually making bonded assemblies. 1.2 The values stated in SI units are to be regarded as the standard. The values in parentheses are for information only. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||
2. Referenced Documents | ||||
|
Chcete pravidelně odebírat informace o nově vycházejících normách z celého světa a to zcela zdarma?
Přihlašte se k odběru. Vše je velice jednoduché a absolutně ZDARMA.
Na výběr máte vydavatele z celého světa.
Poslední aktualizace: 05.05.2024 (Počet položek: 2 897 047)
© Copyright 2024 NORMSERVIS s.r.o.