Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Bursting Strength of Textile Fabrics´Diaphragm Bursting Strength Tester Method
Automaticky přeložený název:
Standardní zkušební metoda pro pevnost v tlaku textilních Fabrics'Diaphragm roztržení Tester Síla metody
NORMA vydána dne 1.1.2013
Označení normy: ASTM D3786/D3786M-13
Poznámka: NEPLATNÁ
Datum vydání normy: 1.1.2013
Kód zboží: NS-24874
Počet stran: 4
Přibližná hmotnost: 12 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
diaphragm bursting pressure, knitted fabric, non woven fabric, ICS Number Code 59.080.30 (Textile fabrics)
Significance and Use | ||||||||||
5.1 This method for the determination of diaphragm bursting strength of knitted, nonwoven and woven fabrics is being used by the textile industry for the evaluation of a wide variety of end uses. 5.2 In cases where test results obtained using the procedures in Test Method D3786 have not been correlated with actual performance, Test Method D3786 is considered satisfactory for acceptance testing of commercial shipments of textile fabrics for bursting strength since the method has been used extensively in the trade for acceptance testing. In cases where disagreement arising from differences in values reported by the purchaser and the supplier when using Test Method D3786 for acceptance testing, the statistical bias, if any, between the laboratory of the purchaser and the laboratory of the supplier should be determined with comparison based on testing specimens randomly drawn from one sample of material of the type being evaluated. 1.1 This test method describes the
measurement of the resistance of textile fabrics to bursting using
a hydraulic or pneumatic diaphragm bursting tester. This test
method is generally applicable to a wide variety of textile
products.
1.2 This test method may also be applicable for stretch woven and woven industrial fabrics such as inflatable restraints. 1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.4 This standard does not
purport to address all of the safety concerns, if any, associated
with its use. It is the responsibility of the user of this standard
to establish appropriate safety and health practices and determine
the applicability of regulatory limitations prior to use.
|
||||||||||
2. Referenced Documents | ||||||||||
|
Historická
1.7.2013
Historická
15.2.2014
Historická
1.1.2010
Historická
1.1.2014
Historická
1.5.2013
Historická
1.7.2012
Chcete pravidelně odebírat informace o nově vycházejících normách z celého světa a to zcela zdarma?
Přihlašte se k odběru. Vše je velice jednoduché a absolutně ZDARMA.
Na výběr máte vydavatele z celého světa.
Poslední aktualizace: 31.01.2025 (Počet položek: 2 222 439)
© Copyright 2025 NORMSERVIS s.r.o.