Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Warp (End) and Filling (Pick) Count of Woven Fabrics
Automaticky přeložený název:
Standardní zkušební metoda pro Warp (End) a plnění (Pick) Počet tkaných textilií
NORMA vydána dne 1.9.2012
Označení normy: ASTM D3775-12
Poznámka: NEPLATNÁ
Datum vydání normy: 1.9.2012
Kód zboží: NS-24827
Počet stran: 4
Přibližná hmotnost: 12 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
construction, fabric, filling pick count, warp end count, woven, ICS Number Code 59.080.30 (Textile fabrics)
Significance and Use | ||||||||||
5.1 This test method is considered satisfactory for acceptance testing of commercial shipments because it has been used extensively in the trade for that purpose. 5.1.1 If there are differences of practical significance between reported test results for two laboratories (or more), comparative test should be performed to determine if there is a statistical bias between them, using competent statistical assistance. As a minimum, use the samples for such a comparative test that are as homogeneous as possible, drawn from the same lot of material as the samples that resulted in disparate results during initial testing and randomly assigned in equal numbers to each laboratory. The test results from the laboratories involved should be compared using a statistical test for unpaired data, a probability level chosen prior to the testing series. If bias is found, either its cause must be found and corrected, or future test results for that material must be adjusted in consideration of the known bias. 5.1.2 This test method is suitable for use with narrow fabrics when the count across the total width is measured in the narrow direction and extrapolated to the number of yarns per centimetre or inch. |
||||||||||
1. Scope | ||||||||||
1.1 This test method covers the measurement of warp end count and filling pick count and is applicable to all types of woven fabrics. 1.2 The values stated in SI units
are to be regarded as the standard. The values given in parentheses
are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||
2. Referenced Documents | ||||||||||
|
Historická
1.8.2011
Historická
1.1.2007
Historická
1.1.2013
Historická
1.7.2014
Historická
1.7.2014
Historická
1.10.2013
Poslední aktualizace: 21.11.2024 (Počet položek: 2 206 478)
© Copyright 2024 NORMSERVIS s.r.o.