Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Specification for Synthetic Brown Iron Oxide Pigment
Přeložit název
NORMA vydána dne 1.10.2019
Označení normy: ASTM D3724-01(2019)
Datum vydání normy: 1.10.2019
Kód zboží: NS-972335
Počet stran: 2
Přibližná hmotnost: 6 g (0.01 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
This specification establishes the properties and requirements for the pigments commercially known as synthetic pure brown iron oxides and its blends, suitable for use in paints and coatings. The pigment, which shall be soft, dry, and finely pulverized, may be manufactured by either of the following methods: precipitation of iron salts; calcination of precipitated iron oxides; blends of synthetic red, yellow, and black iron oxides; and blends of synthetic red, yellow, and black iron oxides plus the addition of carbon black. Specimens shall be suitably sampled and tested, and shall adhere to specified requirements as to total iron oxide, ferrous iron, carbon black, moisture and other volatile matter, organic coloring matter, total sulfates, coarse particles (total residue retained on No. 325 sieve), and water-soluble matter.
Keywords:
brown iron oxide, pigment, synthetic,, ICS Number Code 87.060.10 (Pigments and extenders)
1. Scope | ||||||||||||||||
1.1 This specification covers the pigments commercially known as synthetic pure brown iron oxides and blends. These pigments are suitable for use in paints and coatings. Methods of manufacture are: 1.1.1 Precipitation of iron salts. 1.1.2 Calcination of precipitated iron oxides. 1.1.3 Blends of synthetic red, yellow, and black iron oxides. 1.1.4 Blends of synthetic red, yellow, and black iron oxides plus the addition of carbon black to a maximum of 5.0 %. Small amounts of carbon black are added to obtain tinting colors not obtainable when synthetic brown iron oxide or carbon black are used singly. 1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||||
2. Referenced Documents | ||||||||||||||||
|
Poslední aktualizace: 22.11.2024 (Počet položek: 2 206 568)
© Copyright 2024 NORMSERVIS s.r.o.