Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Measuring Response of Solid Plastics to Ignition by a Small Flame (Withdrawn 2000)
Automaticky přeložený název:
Standardní zkušební metoda pro měření reakce tuhých plastů zapálení malým Plamen (Withdrawn 2000 )
NORMA vydána dne 1.1.1995
Označení normy: ASTM D3713-95
Poznámka: NEPLATNÁ
Datum vydání normy: 1.1.1995
Kód zboží: NS-24589
Počet stran: 7
Přibližná hmotnost: 21 g (0.05 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
Fire-test-response standard, Flammability-plast, Ignition-plast, Plast (electrical insulating), Plast (general), Small-scale burning tests, response of solid plast to ignition by small flame, test,, Vertical position, response of solid plast to ignition by small flame,test, ICS Number Code 83.080.01 (Plast in general)
1. Scope |
1.1 This is a fire-test-response standard. 1.2 This test method covers a small-scale procedure for characterizing the response of a plastic to an ignition source consisting of a small flame of controlled intensity applied to the base of a standard sample being held in a vertical position. 1.3 This standard should be used to measure and describe the reponse of materials, products, or assemblies to heat and flame under controlled conditions and should not be used to describe or appraise the fire hazard or fire risk of materials, products, or assemblies under actual fire conditions. However, results of this test may be used in a fire hazard assessment or a fire risk assessment which takes into account all of the factors which are pertinent to an assessment of the fire hazard or fire risk of a particular end use. 1.4 The values stated in SI units are to be regarded as the standard. Note 1-See Method D3801 which, unless otherwise specified, uses the same specimens for measuring the comparative extinguishing characteristics of solid plastics when tested in a vertical position.1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazard statements are given in 10.1. Note 2-There is no similar or equivalent ISO standard. |
Poslední aktualizace: 21.11.2024 (Počet položek: 2 206 478)
© Copyright 2024 NORMSERVIS s.r.o.