Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ASTM D3677-10e1
Standard Test Methods for RubberIdentification by Infrared Spectrophotometry (Includes all amendments And changes 9/9/2015).
Automaticky přeložený název:
Standardní zkušební metody pro RubberIdentification infračervenými Spektrofotometrie
NORMA vydána dne 1.2.2010
Informace o normě:
Označení normy: ASTM D3677-10e1
Poznámka: NEPLATNÁ
Datum vydání normy: 1.2.2010
Kód zboží: NS-24430
Počet stran: 21
Přibližná hmotnost: 63 g (0.14 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Anotace textu normy ASTM D3677-10e1 :
Keywords:
acrylonitrile-butadiene rubber, balata, butyl rubber, chloroprene, ethylene-propylene rubber, ethylene-propylene-diene rubber, gutta percha, infrared spectrometry, polybutadiene, polyisoprene, nitrile rubber, styrene-butadiene rubber: Vulcanization characteristics, Spectral data--rubber, Chemical analysis--rubber chemicals/materials, Infrared (IR) analysis--rubber, Infrared spectrophotometry, Pyrolysis products, Quantitative analysis/measurement--rubber, Raw rubber, Rubber compounding materials
Doplňující informace
| Significance and Use | ||||||||
|
For research, development, and quality control purposes, it is advantageous to determine the composition of rubbers in cured, compounded products. This test method provides such composition analysis utilizing an infrared technique. |
||||||||
| 1. Scope | ||||||||
|
1.1 These test methods cover rubber identification and are based on infrared examination of pyrolysis products (pyrolyzates) and films. 1.2 These test methods are applicable to rubbers in the raw state and, when compounded, both in the cured and uncured state. 1.3 Since it is customary in infrared spectrophotometry to use wavenumbers (cm−1) rather than Hertz (Hz), the unit for frequency in the SI system, the former is employed throughout this test method. 1.4 This test method assumes that specimens and infrared spectra are prepared and analyzed by experienced personnel and that the equipment is operated according to the manufacturer's direction for optimum performance. No details for operation of infrared spectrophotometers are included in this test method. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in Section 17. |
||||||||
| 2. Referenced Documents | ||||||||
|
Doporučujeme:
