Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ASTM D3677-10(2015)
Standard Test Methods for Rubber´Identification by Infrared Spectrophotometry
Automaticky přeložený název:
Standardní zkušební metody pro Rubber'Identification infračervené Spektrofotometrie
NORMA vydána dne 1.6.2015
Informace o normě:
Označení normy: ASTM D3677-10(2015)
Poznámka: NEPLATNÁ
Datum vydání normy: 1.6.2015
Kód zboží: NS-615032
Počet stran: 21
Přibližná hmotnost: 63 g (0.14 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Kategorie - podobné normy:
Anotace textu normy ASTM D3677-10(2015) :
Keywords:
acrylonitrile-butadiene rubber, balata, butyl rubber, chloroprene, ethylene-propylene rubber, ethylene-propylene-diene rubber, gutta percha, infrared spectrometry, polybutadiene, polyisoprene, nitrile rubber,, ICS Number Code 83.060 (Rubber)
Doplňující informace
| Significance and Use | ||||||||
|
3.1 For research, development, and quality control purposes, it is advantageous to determine the composition of rubbers in cured, compounded products. 3.2 This test method provides such composition analysis utilizing an infrared technique. |
||||||||
| 1. Scope | ||||||||
|
1.1 These test methods cover rubber identification and are based on infrared examination of pyrolysis products (pyrolyzates) and films. 1.2 These test methods are applicable to rubbers in the raw state and, when compounded, both in the cured and uncured state. 1.3 Since it is customary in infrared spectrophotometry to use wavenumbers (cm−1) rather than Hertz (Hz), the unit for frequency in the SI system, the former is employed throughout this test method. 1.4 This test method assumes that specimens and infrared spectra are prepared and analyzed by experienced personnel and that the equipment is operated according to the manufacturer's direction for optimum performance. No details for operation of infrared spectrophotometers are included in this test method. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in Section 17. |
||||||||
| 2. Referenced Documents | ||||||||
|
Doporučujeme:
