Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Performance Specification for Men’s and Women’s Sliver Knitted Overcoat and Jacket Fabrics
Automaticky přeložený název:
Standardní specifikace představení pro muže a rsquo; s a žen & rsquo; s Sliver Pletené a Jacket tkaniny
NORMA vydána dne 1.2.2014
Označení normy: ASTM D3655-14
Poznámka: NEPLATNÁ
Datum vydání normy: 1.2.2014
Kód zboží: NS-24355
Počet stran: 3
Přibližná hmotnost: 9 g (0.02 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
jackets, overcoats, sliver knitted, ICS Number Code 61.020 (Clothes)
Significance and Use | ||
4.1 Upon mutual agreement between the purchaser and the seller, woven fabrics intended for this end use should meet all of the requirements listed in Table 1 of this specification. Characteristic
|
Requirements |
Section |
Bursting strength (Ball Burst)A |
70 lbf (311 N) min |
7.1 |
Dimensional Change: |
|
|
After 5 launderings |
3 % max, in |
7.1 |
After 3 drycleanings |
2 % max, in |
7.2 |
Colorfastness: |
|
|
Burnt gas fumes, 2 cycles: |
|
7.3.1 |
Shade change original fabric |
Class 4B min |
|
Shade change after 1 laundering |
Class 4B min |
7.3.8 |
Sodium Hypochlorite Bleach |
Class 4B min |
7.3.9 |
Powdered Non-chlorine Bleach |
Class 4B min |
|
Laundering:E |
|
7.3.2 |
Shade change |
Class 4B min |
|
Staining |
Class 3C min |
|
Drycleaning: |
|
7.3.3 |
Shade change |
Class 4B min |
|
Crocking:E |
|
7.3.4 |
Dry |
Class 4D min |
|
Wet |
Class 3D min |
|
Water:E |
|
7.3.5 |
Shade change |
Class 4B min |
|
Staining |
Class 4C min |
|
Perspiration (acid phase)E |
|
7.3.6 |
Shade change |
Class 4B min |
|
Staining |
Class 3C min |
|
Light (40 AATCC FU) (xenon arc)A |
Step 4B min |
7.3.7 |
Flammability |
pass |
7.4 |
4.3 Where no prepurchase agreement has been reached between the purchaser and the seller, and in case of controversy, the requirements listed in Table 1 are intended to be used as a guide only. As noted in 4.2, ultimate consumer demands dictate varying performance parameters for any particular style of fabric.
4.4 The uses and significance of particular properties and test methods are discussed in the appropriate sections of the specified test methods.
1.1 This performance specification covers men's and women's sliver knitted overcoat and jacket fabrics composed of any textile fiber or mixture of textile fibers.
1.2 This performance specification is not applicable to knitted fabrics used for interlinings.
1.3 These requirements apply to the length and width directions for those properties where fabric direction is pertinent.
1.4 The following safety hazards caveat pertains only to the test methods portion, Section 7, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Practice for Statements on Number of Specimens for Textiles |
|
Standard Test Method for Bond Strength of Bonded, Fused, and Laminated Apparel Fabrics |
|
Standard Test Method for Bursting Strength of Textile Fabrics—Diaphragm Bursting Strength Tester Method |
|
Standard Test Method for Bursting Strength of Textiles´Constant-Rate-of-Traverse (CRT) Ball Burst Test |
|
Standard Terminology Relating to Apparel |
|
Standard Terminology Relating to Textiles |
Historická
1.5.2012
Historická
1.10.2012
Historická
1.4.2014
Historická
1.2.2009
Historická
1.1.2010
Historická
1.6.2011
Poslední aktualizace: 08.09.2024 (Počet položek: 2 346 217)
© Copyright 2024 NORMSERVIS s.r.o.