Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Practice for Injection Molding Test Specimens of Thermoplastic Molding and Extrusion Materials
Automaticky přeložený název:
Standardní praxe pro vstřikování zkušebních těles z termoplastů pro tváření
NORMA vydána dne 1.3.2014
Označení normy: ASTM D3641-14
Poznámka: NEPLATNÁ
Datum vydání normy: 1.3.2014
Kód zboží: NS-24304
Počet stran: 10
Přibližná hmotnost: 30 g (0.07 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
injection-molding, mold design, test specimen preparation, thermoplastics, ICS Number Code 83.080.20 (Thermoplastic materials)
Significance and Use | ||||||||||||||||||||
5.1 It is well known that plastic test specimens molded under different conditions can have significantly different properties. This practice is designed to minimize those differences by establishing operating protocols without being unnecessarily restrictive. 5.2 Always refer to the ASTM material specification or ISO designation for the material for recommended molding conditions. If not available, consult the material supplier. 5.3 This practice requires the use of adequate quantities of plastic material to find desirable operating conditions and to make the desired test specimens. |
||||||||||||||||||||
1. Scope | ||||||||||||||||||||
1.1 This practice covers the general principles to be followed when injection molding test specimens of thermoplastic molding and extrusion materials. This practice is to be used to obtain uniformity in methods of describing the various steps of the injection molding process and to set up uniform methods of reporting these conditions. The exact conditions required to prepare suitable specimens will vary for each plastic material. Any requirements or recommendations in the material specification that differ from this standard take precedence over those in this standard. Always consult the referenced material document for specimen preparation. If no referenced document exists, then consult the material supplier for specimen preparation guidance and note such in the test report. 1.2 The methodology presented assumes the use of reciprocating screw injection molding machines. 1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
|
|
Standard Test Method for Water Absorption of Plastics
|
|
Standard Terminology Relating to Plastics
|
|
Standard Practice for Determining Surface Temperature of Molds for Plastics
|
|
Standard Test Method of Measuring Shrinkage from Mold Dimensions of Thermoplastics
|
|
Standard Test Method for Deflection Temperature of Plastics Under Flexural Load in the Edgewise Position
|
|
Standard Test Method for Tensile Properties of Plastics
|
|
Standard Test Methods for Determining the Izod Pendulum Impact Resistance of Plastics (Includes all amendments and changes 4/7/2023).
|
|
Standard Test Method for Determining the Charpy Impact Resistance of Notched Specimens of Plastics
|
|
Standard Test Methods for Flexural Properties of Unreinforced and Reinforced Plastics and Electrical Insulating Materials
|
|
Standard Test Method for Vicat Softening Temperature of Plastics (Includes all amendments and changes 9/15/2017). |
Poslední aktualizace: 22.12.2024 (Počet položek: 2 217 000)
© Copyright 2024 NORMSERVIS s.r.o.