Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ASTM D3618-05(2015)
Standard Test Method for Detection of Lead in Paint and Dried Paint Films
Automaticky přeložený název:
Standardní zkušební metoda pro detekci olova v barvách a sušené Paint Films
NORMA vydána dne 1.6.2015
Informace o normě:
Označení normy: ASTM D3618-05(2015)
Poznámka: NEPLATNÁ
Datum vydání normy: 1.6.2015
Kód zboží: NS-591334
Počet stran: 3
Přibližná hmotnost: 9 g (0.02 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Kategorie - podobné normy:
Anotace textu normy ASTM D3618-05(2015) :
Keywords:
lead, lead in paints and dry paint films, spot test for lead,, ICS Number Code 87.040 (Paints and varnishes)
Doplňující informace
| Significance and Use | ||||||
|
4.1 The permissible level of heavy metals in certain coatings is specified by governmental regulatory agencies. This test method provides a fully documented procedure for determining low concentrations of lead present in both water and solvent-reducible coatings to determine compliance. |
||||||
| 1. Scope | ||||||
|
1.1 This test method is intended as a screening test to determine if the solids in a paint contain more than 0.5 % lead. The test described barely detects the presence of 0.4 % but gives a definite positive result at the 0.5 % level. Note 1: This test method may be used to detect the presence of
lead at concentrations higher or lower than 0.5 % by making
appropriate changes in the specimen size and reagent quantities
specified.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.3 Paints giving an unexpected positive or questionable result should be analyzed quantitatively for lead, using Test Method D3335. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazard statements are given in Section 7. |
||||||
| 2. Referenced Documents | ||||||
|
Doporučujeme:
