Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Rubber, Raw-Determination of Gel, Swelling Index, and Dilute Solution Viscosity
Automaticky přeložený název:
Standardní zkušební metoda pro Pryž , Raw - Stanovení gelu , otok Index , a zředěného roztoku Viskozita
NORMA vydána dne 1.7.2009
Označení normy: ASTM D3616-95(2009)
Poznámka: NEPLATNÁ
Datum vydání normy: 1.7.2009
Kód zboží: NS-24230
Počet stran: 5
Přibližná hmotnost: 15 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
dilute solution viscosity (DSV), gel, raw rubber, swelling index (SI), Chemical analysis--rubber chemicals/materials, Dilute solution viscosity, Gel characteristics, Raw rubber, Swelling, Viscosity--rubber, ICS Number Code 83.040.10 (Latex and raw rubber)
Significance and Use | ||
These tests are particularly useful for quality control in the production of synthetic rubbers. Percent gel is a measure of the amount of insoluble rubber present in the chosen solvent. Gel may be introduced intentionally in some rubbers. Variations from a normal level indicate changes in the polymerization system. Swelling index is a measure of the type of gel. Gel with a low-swelling index is referred to as “hard gel” and usually indicates the presence of material that does not break down readily by milling. A high-swelling index normally indicates the presence of a “loose gel” that may be broken down easily by milling. In low-gel or gel-free rubbers, the DSV correlates directly with the molecular weight. Since the viscosity is measured only on the soluble portion of the rubber, the use of DSV to predict molecular weight in rubbers having high gel values is meaningless. |
||
1. Scope | ||
1.1 This test method covers the determination of the dilute solution viscosity (DSV), the gel characteristics, and the swelling index of raw non-oil-extended and non-pigmented SBR and NBR. 1.2 This test method may be used to determine the DSV and gel characteristics of rubbers other than SBR and NBR, however, solvents other than 2-butanone and toluene may be required. 1.3 This test method is not intended for the measurement of micro-gel. 1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||
2. Referenced Documents | ||
|
Chcete pravidelně odebírat informace o nově vycházejících normách z celého světa a to zcela zdarma?
Přihlašte se k odběru. Vše je velice jednoduché a absolutně ZDARMA.
Na výběr máte vydavatele z celého světa.
Poslední aktualizace: 22.11.2024 (Počet položek: 2 206 568)
© Copyright 2024 NORMSERVIS s.r.o.